1. Remove cardboard carton from metal frame. 2. Remove scooter and parts provided for assembly from carton. Removal from crate rt50-r retro scooter set up instructions.
Parts and hardware zip ties battery front wheel headlight panel rear view mirrors tools headlight panel hardware steering column hardware.
Handlebar 3. Attach handlebar assembly to steering stem using hardware provided. Torque bolt to 33 ft.Lbs. 4. Connect electrical components and secure all wires with zip tie. Handlebar assembly steering stem electrical components zip tie bolt nut.
Front wheel 5. Align speed sensor between front wheel and front fork. 7. Remove brake caliper shipping spacer and discard. Attach brake caliper to front forks using bolts provided. Torque bolts to 7 ft.Lbs. Shipping spacer axle bolt speed sensor alignment tab on front fork 6. Place front wheel space...
Headlight panel 9. Connect headlight wire. 10. Insert headlight panel to tabs on scooter and secure with 4mm phillip head screws. Tab headlight panel.
Mirrors 11. Attach left and right mirrors to handlebars secure by tightening nut. Rear mud flap 12. Attach rear mud flap to rear fender with 4mm phillip head screw. Mud flap.
Battery located in floorboard. Battery installation warning the following procedure is very dangerous and should be performed with utmost care and attention. Wear protective eyewear, rubber gloves, and have water available should electrolyte come in contact with skin or eyes. Keep all children away ...
Note: the following page is for vehicles with battery’s containing separate electrolyte pack. Most battery’s will come with the electrolyte already sealed into the battery. Preparing the battery: · place battery on level surface. Remove sealing tape from top. (see figure 20) · take the electrolyte c...
Warning never remove the strip of caps nor add any water or electrolyte. How to initially charge the battery: 1. Connect the red positive (+) cable to the red positive (+) pole of the battery. (see figure 23) 2. Connect the black negative (-) cable to the black negative (-) pole of the battery. (see...
10 13. Fill engine with correct amount of oil. Refer to owners manual for oil types and quantity. 14. Fill gas tank as specified in owners manual. Fuel tank located under seat 15. Refer to owners manual for proper starting instructions. !!Warning!! This engine may be shipped with packing oil. This o...
