Baja sportub series Owner's Manual

Summary of sportub series

  • Page 1

    Ub ub spor spor spor america's get away spa! Ul ® underwriter's laboratories note: important safety instructions. Please read and follow all instructions before installing, operating or enjoying your spa. Please refer to the operational video that is supplied with spa. Save these instructions for fu...

  • Page 2

    A brief history of spas safety instructions ......................................................................................................................................... Pages 2-4 120 volt ozone generator ......................................................................................

  • Page 3

    When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: 1 . Read and follow all instructions. 2. Warning - to reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all time...

  • Page 4

    11. Do not use the spa alone. 12. People with infections, skin sores or open wounds should not use the spa. 13. It is recommended that people shower before and after using the spa in order to keep spa operating cleaner, and to rinse off spa water chemicals. 14. Disconnect all electrical power before...

  • Page 5: Save These Instructions!

    20. Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6 °f. The symptoms of hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness and fainting. The effects of hyper...

  • Page 6

    1. Locate your spa on a solid, level surface that is structurally strong enough to support its filled weight. 2. Installations on wooden decks or balconies should be checked to insure that the floor can support the weight of the full spa and the persons using it. 3. A reinforced poured concrete slab...

  • Page 7: 120 Volt Installation

    Field supplied wiring ground line 1 line 2 neutral factory supplied wiring line 1 - black line 2 - blue neutral - white } } blue blue 120 volt installation the provided power supply cord must be connected to a receptacle with a minimum circuit breaker size of 15 amperes. No other electrical applianc...

  • Page 8

    7.

  • Page 9: Warning

    In order to check for possible leaks, the following steps are performed without the wood skirting in place. To prevent risk of electrical shock, do not use spa at this time. Warning 1. 120 volt units: make sure the power supply cord is "unplugged". 240 volt units: make sure the power supply is "off"...

  • Page 10

    Temperature program keys : the up/down temperature program keys are used to set the desired water temperature. Press the up or down keys to increase (or decrease) the desired temperature setting. The temperature can be adjusted in 1ºf increments from 59ºf to 104ºf (or 15ºc to 40º c). The desired tem...

  • Page 11

    Sportub ii 1057-58 controller operations jet1 - the jet1 button is used to turn the pump on or off at selected speeds. The first press will turn the pump to low speed. The second press will change the pump to high speed. The third press will turn the pump off or return to a heat or filtration mode (...

  • Page 12

    Hydro-quip portable spa equipment if you apply power to system and do nothing else: 1. The primary filter cycle will occur in 24 hours and run for 120 min. This will repeat every 24 hours. 2. The spa will heat up to and maintain 100º f. (the freeze protection mode is available if required.) to set o...

  • Page 13: Jet & Filter  Operation

    Installing your purification dispenser there are several ways that the water chemistry can been maintained in your baja spas. As the photo's indicate below, baja’s built in kleen h20 dispenser incorporates the filter lid for either chlorine / bromine tablets or nature 2 purification system. The natu...

  • Page 14

    13 cabinet installation installation instructions for cabinet drain valve baja spa's equipped with the thru cabinet drain valve will include: ! Cabinet panel with removable 1 ½” black plug . ! Place this panel in the left corner position on models # 1043/44/54/57/58/67/68and in left side panel posit...

  • Page 15

    Daily - check water level, refill if necessary to line on skimmer plate. - check chemical reading and adjust as needed. - for proper filtration, the water should be circulating for at least four hours a day. Weekly - wipe down the water line. - check water flow and clean filter if necessary. Monthly...

  • Page 16

    Wood cabinet: your modular cabinet has been treated with a stain at the factory. It is suggested that the cabinet be treated annually with an additional coat of stain for maximum weather protection. Contact your baja spa retailer for advice on which stain and oil work best in your area. Draining the...

  • Page 17

    17 troubleshooting air lock plumbing system . “bleed” the system, see start-up procedure page 8. Restricted flow.

  • Page 18

    18 smart winter mode/freeze protection: on board temperature sensors continuously monitor water and air temperature. If the temperature inside the control box falls below 59 ° f, the system will start a special program (smart winter mode) to circulate the water in the plumbing. For the next 24 hours...

  • Page 19

    3 flashing dots below the temperature display is an indication that an error has occurred. To identify the error, follow these procedures: 1) open the front cover of the systems control box. 2) verify if the system error led is illuminated on the printed circuit board. System error led not illuminat...

  • Page 20

    Spa delivery checklist optional equipment delivered:______________________________________________ ________________________________________________________________________ ________________________________________________________________________ ____ function use and care of above optional equipment ...