Baja Sportub Owner's Manual - A Brief History Of Spas

Manual is about: Spas

Summary of Sportub

  • Page 1

    Note: important safety instructions. Please read and follow all instructions before installing, operating or enjoying your spa. Please refer to the operational video that is supplied with spa. Save these instructions for future reference. Hottubs.Com rev 110722 spa owner’s manual for.

  • Page 3: A Brief History Of Spas

    A brief history of spas during the 5th century b.C., the mineral springs in greece and the aegean islands served as healing clinics. At one particular clinic on the island of cos, a greek physician hypocrites practiced medicine while writing extensively on hydrotherapy. In the province of leige, bel...

  • Page 4

    Important safety instructions when installing and using this electrical equipment, basic safety precautions should always be followed, including the following: 1. Read and follow all instructions. 2. Warning - to reduce the risk of injury, do not permit children to use this product unless they are c...

  • Page 5: Save These Instructions.

    Important safety instructions, cont’d 21. A fence around your spa with a self-closing and self-latching gate can be the best protection against unauthorized use. If your spa is indoors, lock the door to the room to keep out unauthorized users. 22. Caution - adequate drainage must be provided if the ...

  • Page 6: Installation Guidelines

    Installation guidelines 1. Locate your spa on a solid, level surface that is structurally strong enough to support its filled weight. 2. Installations on wooden decks or balconies should be checked to insure that the floor can support the weight of the full spa and the persons using it. 3. A reinfor...

  • Page 7: Electrical

    Electrical general information all electrical connections must be accomplished by a qualified electrician in accordance with the national electrical code and in accordance with any local codes in effect at the time of installation. All electrical connections must be made in accordance with the wirin...

  • Page 8: Electrical, Cont’D

    Electrical, cont’d ground fault interrupter ground-fault circuit-interrupters and load neutral connection most 240 volt panel mounted ground-fault circuit- interrupter’s (gfci’s) are provided with a “line” neutral connection lead. Since the gfci itself is a 120 volt device, this wire must be connect...

  • Page 9: Initial Startup

    Initial startup warning: in order to check for leaks, the following steps are performed without the skirting in place. To prevent risk of electric shock, do not use spa at this time. 1. Make sure the power supply is off. 2. Check to see that the black drain valve (located to the left side of equipme...

  • Page 10: Equipment Features

    Equipment features note:before filling spa, please familiarize yourself with the features of the equipment module & control spa controller functions pump key: (if the heater setting has been set above the actual water temperature, the pump will activate on its own as the water is heated on low speed...

  • Page 11: Equipment Module

    Equipment features, cont’d programming filter cycles: you may choose to filter the spa 1, 2 or 3 times per day as required to keep the water clean and sanitary. Press and hold the pump key for 5 seconds. The current setting will be displayed as f1, 2 or 3. Use the up & down temperature arrow keys to...

  • Page 12: Winter Program Modes

    0 winter program modes smart winter mode: the system is constantly monitoring the temperature with its circuit board mounted sensors. If the sensor registers an ambient temperature below 59°f, the systems “smart winter mode” will activate. This mode, once activated, will continue for a period of 24-...

  • Page 13: Jet & Filter Operation

    Jet & filter operation air control filter removal turbostream ® open air control fittings when in high speed jets mode to provide air mix to jets. On/off toggle. Pull gray tab and turn lock ring counterclockwise. Remove filter lid and cartridge. After cleaning filter, bleed air out of the filter cav...

  • Page 14: Regular Spa Maintenance

    Regular spa maintenance cleaning the filter: your baja spa comes complete with a 50 sq. Ft. Filter cartridge that is designed to work under pressure. With normal use, this filter should be removed a minimum of once every 30 days, or anytime you notice an appreciable decrease of the flow from the spa...

  • Page 15: Spa Cabinet Instructions

    Spa cabinet instructions position spa in final desired location before assembling free- standing cabinet. Install panel containing drain valve (see below for instructions on how to install drain valve). Position a cabinet corner under a corner of the spa. Position a side panel under spa lip with bla...

  • Page 16: General Troubleshooting

    General troubleshooting the following describes situations and possible solutions to common problems you may encounter as a spa owner. Nothing operates main breaker is off - set to on. Sub-panel breaker off - set to on. Component(s) not plugged in - plug in components. Over-temperature protection on...

  • Page 17

    General troubleshooting, cont’d controller error indicators to assist the user in identifying problems with the spa, the system will display an error message. These messages will be helpful when communicating with your local dealer or qualified technician if a problem should arise. Pressure or flow ...

  • Page 18: Notes

    Notes.

  • Page 20: Hottubs.Com

    Rev 05/2009 hottubs.Com baja products, ltd. 0 north romero road tucson, az 0 customer service ..................................................... 800.845.2252 ext. 310 email address ...........................................................Info2@bajaspa.Com date_____model #_______________________...