X250 dirt bike set up instructions removal from crate 1. Remove cardboard carton. 2. Remove metal frame and parts included..
Parts and hardware gas cap and vent tube side fender side fender number plate tools battery acid rear foot brake pedal.
Rear foot brake pedal handlebar 3. Attach rear foot brake pedal to lever. Bolt size 6mm qty 2. Torque bolts 6-8ft lbs (8-11nm) bolts 4. Attach handlebar to forks using allen head screw. Be sure to place spacer between handlebar clamp and fork. Screw size 8mm qty 4. Torque bolts 15-18 ft.Lbs (20-25nm...
Ignition switch number plate 5. Attach ignition switch assembly to handlebars and attach electrical plug to wire harness. Screw size 6mm qty 2 6. Attach number plate bolt size 6mm qty 2.
Side covers gas cap 7. Attach left and right side fenders. Bolt size 6mm qty 6 (3per side) 8. Twist gas cap onto gas tank..
Battery warning the following procedure is very dangerous and should be performed with utmost care and attention. Wear protective eye wear, rubber gloves, and have water available should electrolyte come in contact with skin or eyes. Keep all children away from the area while this procedure is being...
Battery preparing the battery: · place battery on level surface. Remove sealing tape from top. (see figure 1) · take the electrolyte container out of the plastic bag. · place electrolyte container upside down with the sealed silver mouths of the electrolyte bottles in line with the six filler holes ...
Battery how to initially charge the battery: 1. Connect the red positive (+) cable to the red positive (+) pole of the battery. (see figure 5) 2. Connect the black negative (-) cable to the black negative (-) pole of the battery. (see figure 6) note: the red positive (+) cable has a larger diameter ...
Gas and oil 10. Fill gas tank as specified in owners manual. 11. Refer to owners manual for proper starting instructions. !!Warning!! This engine may be shipped with oil in it. This oil should be drained and replaced with new engine oil as described in the owners manual. Never attempt to start the e...
