Bajaj Majesty Zero Worry User Manual - page 5
bajaj electricals limited Page 5 of 6
5.
When the water has reached the set temperature green light will go OFF. This indicates that the thermostat
has operated and has switched OFF the power supply to the unit. You should withdraw the water only after
the green light has switched OFF. Hot water
at desired temperature is now available for
use.
6.
It takes time for the water to get heated.
Therefore, switch ON the unit well in advance
before use. The Heater unit can always be
kept ON. Insulation keeps the water hot and
thermostat makes sure that the electric
supply is alternately switched ON and OFF.
7.
Every once in a while, check the working of
the neon lamps to make sure that the
thermostat and thermal cut-out are working
properly.
8.
The red neon lamp glows ON when i) the
thermostat falls OR ii) water
temperature reaches boiling point OR iii)
the heater unit is operating without
water. This indicates that the thermal
cut-out has operated thereby switching
OFF the main power supply to the unit.
In such a case contact the nearest Bajaj
sales or service centre.
9.
The power supply to the Heater can be kept
ON continuously. But it is advisable to switch
it OFF when the unit is not in use for a long
time to save on electricity.
INSTALLATION CHART (FIG. 4)
i.
Inlet water pressure is less than 30 P.S.I. OR
ii.
Height of water tank is less than 70 ft. from
the water heater OR
iii.
Water tank is situated less than 5 floors from
the water heater. In such a case if possible
remove the vent nut and extend the vent
pipe up to the top level of overhead water
supply tank.
INSTALLATION CHART (Fig. 5)
i.
Inlet water pressure is more than 30 P.S.I.
OR
ii.
Height of water-tank is more than 70 ft. from
the water heater OR
iii.
Water tank is situated more than 5 floors
from the water heater. In such a case if
possible remove the vent nut and extend the
vent pipe up to the top level of overhead
water supply tank.
Pre and Post operative care
Precautions:
1.
Read Installation and Operating instructions
carefully.
2.
Get a qualified plumber/electrician to install
the unit.