Bajaj Pulsar 150 CC DTS-i User Manual

Other manuals for Pulsar 150 CC DTS-i: User Manual

Summary of Pulsar 150 CC DTS-i

  • Page 1

    Dear customer, congratulations on choosing “bajaj pulsar 150 cc dts-i” , one of the finest vehicle in the country brought to you by bajaj auto limited. Before you prepare for riding, please read this user's guide carefully to familiarize yourself with the mechanism and the controls of the vehicle. T...

  • Page 2

    Table of contents description identification data....................................................................................................................................1 technical specifications................................................................................................

  • Page 3

    Technical specifications 2 engine : 4 stroke, single cylinder, natural air cooled. Bore x stroke : 58.00mm x 56.40mm engine displacement : 149.01 cc compression ratio : 9.5 + 0.5 : 1 max. Net power : 14.09 ps at 8500 rpm max. Net torque : 12.76 nm at 6500rpm ignition system : microprocessor controll...

  • Page 4

    Location of parts steering cum ignition lock : it has three positions. To lock the steering : to lock the steering, turn the handle bar to the left or right. Push & release the key. Turn the key to “lock” position and remove the key. To unlock the steering : to unlock the steering, insert the key in...

  • Page 5

    Fuel tank cap • to open the fuel tank cap, lift the flap (a) , insert the key in the lock and turn it clockwise. • to lock ‘fuel tank cap’ gently press the cap. Fuel tap fuel tap lever has following positions. On : when fuel level is above reserve position. Res : when fuel level is below reserve pos...

  • Page 6

    Caution : while starting ensure that engine kill switch is in on ( ) position. Keeping the kill switch in off position engine will not start. Right handle bar switches e. Head light switch : it has 3 positions. : all lamps 'off'. : while engine running, tail lamp and pilot lamps ‘on’. : while engine...

  • Page 7

    Location of parts 9 battery • it is located inside the ‘side cover’ lh. • always maintain electrolyte level in each cell between max and min level lines. • always keep a watch on battery charge level indicating icon, if it flashes (indicates battery is in low charged condition), show the vehicle to ...

  • Page 8

    Caution : do not operate the starter continuously for more than 5 seconds. Wait for 15 seconds before next crank. After three continuously cranking the function will be disable after 20 seconds. It can be unable again. How to ride your bike 12 note : the motorcycle is equipped with a starter lockout...

  • Page 9

    • drive smoothly & steadily at speed between 40 and 50 km/h . • drive at constant speed; avoid sudden accelerations & harsh braking as far as possible. Plan your trips properly with minimum start-stops. • change the gear judiciously according to the speed requirements. Drive as far as possible in hi...

  • Page 10

    • always wear helmets while driving or riding. Your helmets should confirm to appropriate standards. • read thoroughly the instructions in this manual and follow them carefully. • avoid unnecessary accessories for the safety of both rider and other motorists. • get familiar and follow traffic rules ...

  • Page 11

    Drive chain slackness • chain top edge to be kept between the two marks during chain slackness adjustment. • care should be taken, that the chain should never run dry. • lubricate chain from outside with sae 90 oil at every 500 kms. • chain slackness will have to be adjusted whenever required. Wheel...

  • Page 12

    Before riding the motorcycle be sure to check the following items. Please give proper importance to these checks and perform all of them before riding the motorcycle. If any irregularities are found during these checks, refer to the maintenance chapter and see authorised dealer / service center for ...

  • Page 13

    Note - more frequent cleaning may be required when driving in dusty condition. Periodic maintenance & lubrication chart 22 1. Servicing 3 3 3 3 3 3 3 1st - 750 kms / 30 days 2nd onward @5000 kms 2. Engine idling speed / co% a a a a a a a a 3. Valve tappet clearance a a a a a a a a 4. Engine oil (baj...

  • Page 14

    Periodic maintenance & lubrication chart 24 33. Drive chain ‘o’ ring type (if applicable) l at every 500 kms 34. Drive chain remove, clean, inspect' & lubricate (o/h) cl, l cl, l cl, l cl, l at every 10000km 35. Drive chain link lock r r r r replace at every 10000km 36. Wheel brg (for non sealed brg...

  • Page 15

    1. Fill adequate petrol into petrol tank for proper flow of petrol to the carburettor. Q 2. Check all locks, p.T. Cap, ignition switch, steering lock, side cover. Q 3. Check for smooth operation for fuel cock. Q 4. Check engine oil level and top up if required. Q 5. Check all controls for proper fre...

  • Page 16

    Parts always insist on for optimum performance of vehicle for prolonged life of components & vehicle for economical maintenance cost genuinity test genuine m.R.P. (incl. Of all taxes) in rs. For qty. Packed 57.43 03100802 p0001 55.58 in assam, karnataka, manipur, m.P., nagaland, u.P., & uttaranchal ...