Dear customer, congratulations on becoming the proud owner of a “bajaj pulsar 150 dts-i” motorcycle, one of the finest motorcycles in the country. Your safety and the safety of others is extremely important. Hence, before you ride the bike, please read this owner's manual carefully and familiarize y...
Table of contents description identification data..........................................................................................................................................................................1 technical specifications..........................................................
Warning this indicates that a potential hazard or injury to you or other persons and to the vehicle can happen, if the advise provided is not followed. Safety and warning information caution this indicates that a potential hazard that could result in vehicle damage. Follow the advise provided with t...
Identification data the frame and engine serial numbers are used to register the motorcycle. These are the unique alpha-numeric codes to identify your vehicle from others of the same model and type. 1 frame number location : on the lh side of steering tube. (alpha-numeric - 17 digits). Engine number...
2 engine : 4 stroke, single cyl., natural air cooled. Bore x stroke : 58.00 mm x 56.40 mm engine displacement : 149.01 cc compression ratio : 9.5 + 0.5 : 1 max. Net power : 15.05 ps at 9000 rpm max. Net torque : 12.45 nm at 6500 rpm ignition system : microprocessor controlled digital cdi spark plug ...
3 location of parts 1. Fuel level indicator : fuel level indicator shows available fuel in fuel tank & reserve indicator also. 2. Tachometer : it shows the engine speed in rpm. 3. Odometer : the odometer shows the total distance that the vehicle has accumulated. 4. Steering cum ignition switch : key...
4 location of parts lock : steering locked. Ignition off. Off : steering unlock. Ignition off. On : steering unlock. Ignition on. Steering cum ignition lock : it has three positions. To lock the steering : to lock the steering, turn the handle bar to the left or right. Push & release the key. Turn t...
Location of parts fuel tank cap • to open the fuel tank cap, lift the flap, insert the key in the lock and turn it clockwise. • to lock ‘fuel tank cap’ gently press the cap. Fuel tap fuel tap lever has following positions. On : when fuel level is above reserve position. Res : when fuel level is belo...
Location of parts left handle bar switches a. Dipper switch : when headlight is on, high or low beam can be selected with the dipper switch. Hi beam indicator light located on speedo console will light up when high beam is selected. : high beam : low beam b. Turn signal switch : when the turn signal...
G f e location of parts 7 right handle bar switches e. Head light switch : it has 3 positions. : all lamps 'off'. : while engine running, tail lamp, meter lamp and pilot lamp/s ‘on’. : while engine running, head lamp, pilot lamp/s, tail lamp and meter lamps ‘on’. F. Starter button : starter button o...
Location of parts 8 a b d c removal of side cover lh or rh • insert the key into the cover lock and turn the key clockwise & pull the ‘side cover’ out from the bottom. • pull front side of ‘side cover’ to release lug (a) provided on ‘side cover’ from hole (b) provided on ‘fuel tank’. • slide the ‘si...
Location of parts battery • it is located inside the ‘side cover’ lh. • always maintain electrolyte level in each cell between max and min level lines. • always keep a watch on battery charge level indicating icon, if it flashes (indicates battery is in low charged condition), show the vehicle to au...
Location of parts removal of seat • remove ‘side cover’ lh. • pull the ‘seat release cable’ (a) to release seat lock. Keeping cable pulled, tap the center of seat, lift the seat from rear end and slide it towards tail lamp to remove seat. Fitment of seat • match & insert the bracket ( ‘1’ of fig. ‘b...
How to ride your bike 11 proper running-in is important for the better life and trouble free performance of the vehicle. • during first 2000 kms running-in period do not exceed following speed limits. Kms 1st 2nd 3rd 4th 5th 0 - 1000 15 30 45 55 65 1000 - 2000 20 40 55 65 75 • always keep the speed ...
How to ride your bike 12 warning : when shifting down to lower gear, do not shift at such a high speed that the engine rpm rises excessively and which may cause the rear wheel to skid. Braking : • close the throttle completely, leaving the clutch engaged (except where shifting gears) so that the eng...
How to ride your bike 13 • when stopping, always apply both brakes at the same time. De-clutch as necessary to keep the engine from stalling. Stopping the vehicle : • close the throttle completely. • shift the transmission into neutral. • bring the vehicle to complete stop. • turn the ignition switc...
Safe riding tips 14 • always wear helmets while driving or riding. Your helmets should conform to appropriate indian standards. • read thoroughly the instructions in this manual and follow them carefully. • avoid unnecessary accessories for the safety of both rider and other motorists. • get familia...
A b b 15 • check engine oil level every day before starting the vehicle. • always maintain engine oil level between upper & lower mark provided on cover rh. Engine oil level checking : • park the vehicle on level surface on center stand. • check oil level through oil inspection gauge as shown in pho...
16 general maintenance information drive chain slackness • chain top edge to be kept between the two marks during chain slackness adjustment. • care should be taken, that the chain should never run dry. • lubricate chain from outside with sae 90 oil at every 500 kms. • chain slackness will have to b...
17 battery : 12v - 9 ah, mf • battery is located inside ‘side cover’ lh. • always ensure that battery electrolyte level is in between max & min level marks. • check & top up battery by distilled water if electrolyte level is below min level mark. • battery life would get adversely affected if top up...
18 front brake fluid level • front brake fluid master cylinder reservoir is located near rh switch on handle bar. • to check oil level, keep the vehicle on centre stand with handle bar in straight ahead position. • always ensure that brake fluid level is above ‘min’ mark given on inspection window. ...
Daily safety checks 19 before riding the motorcycle be sure to check the following items. Please give proper importance to these checks and perform all of them before riding the motorcycle. If any irregularities are found during these checks, refer to the maintenance chapter and see authorised deale...
20 non-use maintenance non-use maintenance is necessary if a vehicle remains off road for a longer duration (more than 15 days**). The correct and careful non-use maintenance carried out before storing the vehicle will prevent the vehicle from rusting and from such other non-operational damages like...
Periodic maintenance and lubrication chart 21 1. Servicing 3 3 3 3 3 3 3 1st - 750 kms / 30 days 2nd onward @5000 kms 2. Engine idling speed / co% a a a a a a a a 3. Valve tappet clearance a a a a a a a a 4. Engine oil* - bajaj dts-i 10000 r r r r r replace at 10000 kms* 5. Oil strainer / centrifuga...
22 periodic maintenance and lubrication chart 17. Rear brake pedal free play c, a c, a c, a c, a c, a c, a c, a c, a 18. Brake lining or pad wear cl, r cl cl cl, r cl cl cl, r replace at every 15000 kms 19. Brake fluid level / top up / replace (if applicable) c, a, r c, a c, a c, a c, a c, a c, a r ...
Periodic maintenance and lubrication chart 23 33. Drive chain ‘o’ ring type (if applicable) l at every 500 kms 34. Drive chain remove, clean, insp. & lubricate (o/h) cl, l cl, l cl, l cl, l at every 10000 kms 35. Drive chain link lock r r r r replace at every 10000 kms 36. Wheel bearing (for non sea...
24 schedule for periodic part replacement bajaj auto recommends the following periodic parts replacement for optimum performance of your vehicle as per the schedule. Qty 1000 ml 1 nil 1000 ml 1 1 1 1 2 nos. 1 1 2 1 1 2 1st free 2nd free 3rd free 1st paid engine oil engine oil filter / paper oil filt...
25 schedule for periodic part replacement qty 1000 ml 1 1 1 1 1 1 1 1 300 ml nil 2nd paid 3rd paid engine oil engine oil filter / paper oil filter air filter cover ‘o’ ring carburettor rubber duct fuel pipes steering stem bearing cone set (if required) rear wheel rubber dampers (if required) engine ...
26 schedule for periodic part replacement qty 1 11 75 ml 1 1 1 2 1 4th paid air cleaner element brake pad / shoe brake fluid (if applicable) steering stem bearing cone set (if required) rear wheel rubber damper (if required) drive chain lock valve oil seals cylinder head gasket type of service item ...
28 warranty scope & limits bajaj auto limited gives the following warranty in respect of the motorcycle manufactured by them. Every possible care and precaution has been taken to ensure quality in respect of the material & workmanship in the vehicles manufactured by us. Bajaj auto limited will repai...
Warranty : scopes and limits 29 enables him to remove and despatch the part/parts attributing to the manufacturing defect to the company. B. Produces the owner's manual, in original, to enable that dealer to verify the details. It must be expressly understood that claims forwarded directly to us by ...
30 warranty : scopes and limits 7. All chrome plated parts are prone to rust or corrosion in coastal area or in acidic environment or due to neglected cleaning etc. However chrome film peeling is covered under warranty in general atmospheric conditions. Blue/ yellow colouration of silencer near exha...
Use only bajaj genuine parts parts always insist on for optimum performance of vehicle for prolonged life of components & vehicle for economical maintenance cost genuinity test genuine m.R.P. (incl. Of all taxes) in rs. For qty. Packed 57.43 03100802 p0001 55.58 in assam, karnataka, manipur, m.P., n...
