BakBone Software DAT 432 Application Notes - page 3
Device Application Notes For NetVault
Revision A7
BakBone Software, Inc.
3
10/24/2003
Installation:
¾
Prerequisites
9
Ensure cabling and termination is configured correctly by referring to the Manufacturer User’s
Guide.
9
Attach Device to host system by referring to the Manufacturer’s Installation Guide.
9
Power ON Unit, if required, and allow for the completion of the device’s POST (Power-On Self-
Test).
9
Ensure default configuration settings on the library front LCD panel. Refer to the Installation
and Operation Manual.
9
Configure SCSI IDs via front panel as desired. This autoloader is a LUN 1 arm device, where
the robotic arm changer shows up at LUN 1 under the SCSI ID of the tape drive. Ensure this
device is set to unique SCSI ID. The default configuration is target ID 6:LUN 0 for the tape
drive and target ID 6:LUN 1 for the robotic arm changer. For further details refer to the
Installation and Operation Manual.
9
Power on and boot up host computer system.
¾
Selection of Device within NetVault
Library Robotic Arm Selection
9
Select the Device Management Facilities.
9
Select to Add a Library.
9
Select Server/Client machine and open it to view attached Robotic Libraries in “Library
Selection” tab.
9
Select Library arm under Library Selection and verify the correct device is displayed in the
Selected Library area on the right. (Figure 1.)