Bakers Pride 24BPV4B20N Operation Manual - Maintenance Instructions

BP SERIES RANGES OPERATION MANUAL

4

The arrow shown on the bottom of the regulator body 

shows the gas flow direction, it should point downstream 

to the appliance. The red air vent cap on the top is part 

of the regulator and should not be removed.

Any adjustments to the regulator should be made 

by qualified service personnel only with the proper 

equipment.

Connections

Please check installer supplied intake pipes visually 

and / or blow them with compressed air to clear any dirt 

particles, threading chips or any other foreign matter 

before installing a service line. When gas pressure is 

applied, these particles could clog orifices.

All connections must be sealed with a joint compound 

suitable for LP gas, and all connections must be tested 

with a soapy water solution before lighting any pilots.

Flexible Couplings, Connector and Casters

For an appliance equipped with casters, the installation 

shall be made with a connector that complies with the 

Standard for Connectors for Movable Gas Appliances, 

ANSI Z21.69 or Connectors for Moveable Gas 

Appliances, CAN/CGA-6.16, and a quick disconnect 

device that complies with the Standard for Quick 

Disconnect Devices for Use With Gas Fuel, ANSI 

Z21.41, or Quick Disconnect Devices for Use With Gas 

Fuel, CANI-6.9.

If disconnection of the restraint is necessary, make 

sure to reconnect restraint after the appliance has been 

returned to its originally installed position. Domestic gas 

or water connectors are not suitable.

Restraining device may be attached to the back frame / 

panel of the unit.

If the appliance is to be installed with casters, a flexible 

connector must be used and the same ANSI standards 

apply. Locking front casters are provided to limit the 

movement of the appliance without depending on the 

connector or associated piping. A suitable strain relief 

must be installed with a flexible connector.

All connections must be sealed with a joint compound 

suitable for LP gas and all connections must be tested 

with soap water solution before lighting pilots.

MAINTENANCE INSTRUCTIONS

Initial Pilot Lighting

When lighting pilots and checking for leaks, do 

not stand with your face close to the combustion 

chamber.

CAUTION

All appliances are adjusted and tested before leaving 

the factory, effectively matching them to sea level 

conditions. Adjustments and calibrations to assure 

proper operation may be necessary on installation to 

meet local conditions, low gas characteristics; correct 

possible problems caused by rough handling or 

vibration during shipment and are to be performed only 

by qualified service personnel.  

These adjustments are the responsibility of the customer 

and/or dealer and are not covered by our warranty.

Check all gas connections for leaks with a soapy water 

solution before lighting any pilots.

Do not use any flame to check for leaks.

CAUTION

Before lighting any pilots, make sure that burner valves 

and thermostats are turned “OFF”.

Top Burners / Raised Griddle / Broiler

All top section burners are equipped with constant 

burning pilots. These are to be manually lighted 

immediately after the gas is turned on and the system is 

checked for leaks. Burner pilots are provided for each 

burner and can be rechecked for proper adjustment. 

All adjustments can be made with a screw driver to the 

brass pilot valve accessible through the valve cover.

Griddle

The pilot should be lighted immediately after the gas 

is turned on and the system is checked for leaks. The 

pilot can be reached with a long match through the 

valve cover, or by lifting the plate upward and accessing 

through the top. Adjustment of the pilot flame can be 

made with a screwdriver to the pilot valve, accessible 

through the valve cover.