1. DL manuals
  2. Bakers Pride
  3. Oven
  4. COC-E
  5. Installation And Operating Instructions Manual

Bakers Pride COC-E Installation And Operating Instructions Manual

Manual is about: EQUIPMENT PRICE LIST

Summary of COC-E

  • Page 1

    Installation and operating instructions cyclone series electric convection ovens models: co11-e and coc-e intended for other than household use retain this manual for future reference oven must be kept clear of combustibles at all times this equipment has been engineered to provide you with year rou...

  • Page 2: Index

    Index installation instructions operating instructions section item page section item page 1 receiving 2 2 location & minimum clearances 2 3a set-up & mounting for coc-e1 3 3b set-up & mounting for co11-e 3 4 electrical connections 4 5 initial start up 5 6 system check & rotary controls 5 7 steam in...

  • Page 3

    Minimum clearances coc-e1 co11-e1 inches mm inches mm right 1 25 1 25 left 1 25 2 50 rear 1 25 1 25 3a. Set-up / mounting for coc-e1 1. Coc-e1: direct placement on counter counter-top installation must conform to one of the following methods: a. Make sure the counter is level. B. Clean the area wher...

  • Page 4

    4 c. Use proper lifting equipment to raise the unit, and while suspended attach the two left legs in the same manner. A. After unpacking the unit, remove legs and any other material from inside the oven. B. Tilt the bottom oven onto its left side and attach the two mounting plates to the right under...

  • Page 5

    2. Field connections a. Remove access panel from the right side of the oven. B. Feed power cable (supplied by the customer) through the access hole in the rear of the oven and pull the cable to the front of the oven under the access panel where it may be attached to the cable support bracket. C. Fol...

  • Page 6

    7. Steam injection option the solenoid valve for steam injection is mounted behind the service panel on the right hand side of the unit on coc-e and on the back of the unit on co11-e. It is pre-wired at the factory. The electronic timer is pre-set at the factory. A ¼” copper tubing with a compressio...

  • Page 7

    3. Cook & hold rotary control 4. Optional steam injection rotary control a. Close the oven door(s). B. Turn selector switch to “high” or “low” position. The green indicator light near the selector switch will be illuminated. C. Turn the thermostat knob to the desired cooking temperature. D. Upon rea...

  • Page 8

    8 oven interior: clean the racks and rack support guides: clean the stainless steel interior: clean the blower wheel: clean the porcelain interior: clean the exterior stainless steel: open the doors and remove all wire racks and rack support guides. Take them to the sink and thoroughly clean in warm...

  • Page 9

    4. Servicing 1. The power supply to the unit must be disconnected prior to service. 2. Most of the service to this unit can be performed from the front and/or the control panel side. 3. For proper service, access to the control panel side of the unit is required. 4. It is necessary to have access to...

  • Page 10

    17 b l k 2 b l k a4 w h t c2 wht a5 w h t a6 wht 9 blk 10 blk h5 w h t h3 wht h6 wht 6 wht 16 w h t 1 b l k com no l2 9 b l k 12 b l k s b l k a3blk c1 blk 13 wht a3 blk a4 wht 4 3 2 p4 p3 p2 p1 buzzer timer 2 1 4 s selector switch pilot light (power) door switch c nc no butt connector 208v 1 220-24...

  • Page 11

    4- all poles disconnect must be provided by the installer rc 1 f, 250v ac m 1 f, 250v ac m m1 f, 250v ac 2 speed 250v 10 b l u c2 brn s b l u 2 b l u 2 b l u 1 b r n c1 blu 17 b l u h5 b r n a5 b r n a6 brn a3 blu a4 brn a4 b r n buzzer timer 2 1 4 s 14 b l k 18 w h t used only on co11-e circuit bre...

  • Page 12

    16 what is covered this warranty covers defects in material and workmanship under normal use, and applies only to the original purchaser providing that: ♦ the equipment has not been accidentally or intentionally damaged, altered or misused; ♦ the equipment is properly installed, adjusted, operated a...