Ul r listed listed commercial electric cooking appliance us c bakers pride oven co., inc. 30 pine street new rochelle, ny 10801 (914) 576-0200 phone (800) 431-2745 us & canada (914) 576-0605 fax www.Bakerspride.Com web address installation and operating instructions floor model electric deck ovens i...
2 index installation instructions section item page 1 receiving 3 2 location and minimum clearances 3 3 installation 3 4 stacking 5 5 steam option 5 6 installation of decks 6 7 electrical connection 7 8 system check 8 9 initial start-up 9 operating instructions section item page 1 general baking 9 2...
3 installation instructions models covered model number of elements total kw phase ep1(2,3)-8-3836 8 elements per deck 8 kw per deck 1 or 3 phase ep1(2,3)-8-5736 12 elements per deck 12 kw per deck 1 or 3 phase eb1(2,3)-8-3836 8 elements per deck 8 kw per deck 1 or 3 phase eb1(2,3)-8-5736 12 element...
4 f) move the oven to its final location (in case of casters, release the brakes, then reapply once in position), maintaining the minimum distances specified in section 2. Above. G) remove all loose parts and packages from the oven interior. H) insert the short piece of tapered pipe supplied (see fi...
5 4. Stacking these ovens can be stacked up to three high. Each unit is built exactly the same, so it does not matter in what order they are stacked. However, in case of a mix of 8” and 12” deck heights, it is advisable to place the higher deck(s) on the top, e.G.: mount the legs to one of the lower...
6 a b c d e g h j f i l k figure #5 6. Installation of decks steel decks steel decks for bake and roast application are factory installed and no further installation is required. Ceramic decks ceramic decks for pizza application are shipped in a separate carton. Depending on the model, two (see fig....
7 figure #6 6a 6b figure #7 7a 7b caution overexposure to smoke or fumes may cause nausea and dizziness. Be sure the oven is placed in a well ventilated area. ! ! 7. Electrical connection general instructions a) only a licensed electrician should make the electrical connections. B) make sure electri...
8 c) feed power cable (supplied by the customer) through the access hole at the left side (see fig 5g) or at the bottom (see fig. 5h) of the oven and pull the cable to the front of the oven where it may be attached to the opening in the oven frame. See fig. 5i). D) following the appropriate wiring d...
9 caution overexposure to smoke or fumes may cause nausea and dizziness. Be sure the oven is placed in a well ventilated area. ! ! 9. Initial start-up after installation, your oven will need a few hours to evaporate the moisture in the deck and in the insulation and to burn off the thin coat of oil ...
10 f) frequently scrape and brush off decks to remove burnt residue which can cause an 'off' flavor and an increase in the bake time. G) heavily topped pizza or pan pizza require lower bake temperatures and longer bake times as compared to a regular thin pizza with light toppings. H) bubbles in fres...
Please fill in the above rating plate inrormation and keep for future reference. This information will be necessary in the future when ordering parts or requesting warranty service. Date purchased: purchased from: 11 do not use water or other liquids on the baking decks as that may cause them to cra...
1 2 electric wiring diagram ep(b,r) -8(12) -5736 208, 240 or 440-480v, 1 ph, 2 w or 3 ph, 3 w dwg. 1048-121 7/02 3.
1 3 electric wiring diagram ep(b,r) -8(12) -3836 208, 240 or 440-480v, 1 ph, 2 w or 3 ph, 3 w dwg. 1048-122 7/02.
. 1 4 electric wiring diagram ep(b,r) -8(12) -5736 230/400v - star dwg. 1048-123 7/02.
1 5 . Electric wiring diagram ep(b,r) -8(12) -3836 230/400v - star dwg. 1048-124 7/02.
16 what is covered this warranty covers defects in material and workmanship under normal use, and applies only to the original purchaser providing that: ♦ the equipment has not been accidentally or intentionally damaged, altered or misused; ♦ the equipment is properly installed, adjusted, operated a...
