Balanced Audio Technology VK-50 Owner's Manual - Vk-50 Programing Functions
9
Turning the display OFF: The VK-50 display can be turned OFF or ON at any time by
simply pressing the DISPLAY button on your VK-R3 remote control transmitter.
With the display OFF, issuing any remote control command that would normally require a
display change (i.e.: Volume, Input selection, Fade) will automatically turn the display back
ON.
MUTE Function:
The VK-50 has two mute modes: manual and automatic. The blue LED above the Mute button
goes ON when the unit is in MUTE state. To MUTE the VK-50, depress the MUTE button located
on the right side of the front panel. Depressing this button again will return the unit to its normal
operation and turn the mute LED off.
When the unit is powered up it automatically self-mutes until the proper operating points of the
circuitry are reached. It will then automatically go into Play mode, provided the Mute function was
not activated (the blue Mute LED is Off).
Turning the VK-50 OFF even for short time, will make the unit reset its power sequencing circuit
and mute its output. It will then require 50 seconds for the unit to become operational again.
VK-50 PROGRAMING FUNCTIONS
The VK-50 programming functions allow the user to optimize the unit configuration for any
particular system set up. The flexible programming facility defines each signal input with a group