Balanced Audio Technology VK-P5 Owner's Manual - Configuration Switches
Configuration Switches
WARNINGS:
Please make sure that the VK-P5 is turned OFF and your preamplifier is in MUTE
before changing the state of any internal configuration switches in VK-P5.
Hazardous voltages are present on the unit’s printed circuit board. DO NOT operate
the VK-P5 with its top cover removed.
This section describes the setting of internal configuration switches that are located inside the
VK-P5 phono preamplifier. In order to access these switches, do the following:
1. Turn the VK-P5 OFF and disconnect the power cord from the power line
receptacle.
2. Remove the top cover, using the supplied Torx T-10 wrench.
Figure 1 depicts the locations of the VK-P5 internal configuration switches. These include:
1. Left and right channel cartridge loading switches S101 and S201
2. Gain switch S2
3. Gain potentiometers R130 and R230
The following section describes the operation of these controls.