BALAY 3VK300BC - annexe 2 Instruction Manual

Summary of 3VK300BC - annexe 2

  • Page 1

    Y w w w . B a l a y . E s instruction dishwasher en manual 9 0 0 0 4 3 8 9 3 0 (8 9 0 8 -1 ).

  • Page 2

    Start end 9h 6h 3h reset 3 sec. 8 9 10 7 1 3 2 5 6 4 21 22 24 25 20 23 26 27 28.

  • Page 3

    En table of contents safety instructions . . . . . . . . . . . . . . . . . 4 delivery . . . . . . . . . . . . . . . . . . . . . . . . 4 installation . . . . . . . . . . . . . . . . . . . . . . 4 in daily use . . . . . . . . . . . . . . . . . . . . . 4 children in the household . . . . . . . . . . 4 ...

  • Page 4

    En 4 delivery – check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier. – please dispose of the packaging material in an environmentally friendly manner. – do not let children play with packaging and its parts. The...

  • Page 5

    En 5 damage – the appliance may be repaired and opened up by a technician only. To do this, disconnect the appliance from the power supply. Pull out the mains plug or switch off the fuse. Turn off the tap. Disposal – make redundant appliances unusable to prevent subsequent accidents. – dispose of th...

  • Page 6

    En 6 to ensure good washing results, the dishwasher requires soft water, i.E. Containing low amounts of lime, otherwise white limescale will be deposited on the utensils and inner container. Tap water above a specific degree of water hardness must be softened, i.E. Descaled, for use in a dishwasher....

  • Page 7

    En 7 using special salt always refill with special salt immediately before switching on the appliance. This ensures that overrun special salt solution is immediately washed out and does not corrode the rinsing tank. – open the screw-type cap of the compartment 12. – fill the tank with water (only re...

  • Page 8

    En 8 as soon as the rinse-aid refill indicator p is lit on the fascia, there is still a rinse-aid reserve of 1 – 2 rinsing processes. Refill with rinse aid. The rinse aid is required for stain-free utensils and clear glasses. Use only rinse aid for domestic dishwashers. Combined detergents with rins...

  • Page 9

    En 9 not suitable – cutlery and utensils made of wood. – delicate decorative glasses, craft and antique utensils. These decors are not dishwasher-proof. – plastic parts not resistant to heat. – copper and tin utensils. – utensils which are soiled with ash, wax, lubricating grease or ink. Aluminium a...

  • Page 10

    En 10 cutlery basket you should always place cutlery unsorted with the points downwards. To prevent injuries, place long, pointed implements and knives on the knife shelf. Folding spikes * * depending on model the spikes can be folded down to improve arrangement of pans, bowls and glasses. You can u...

  • Page 11

    En 11 adding detergent – if the detergent dispenser 1r is still closed, press the lock 1z to open the detergent dispenser. Pour detergent into the dry detergent dispenser 1r only (insert tablet flat, not on its edge). Dosage: see manufacturer’s instructions on the packaging. The graduated detergent ...

  • Page 12

    En 12 the max. Possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. Programme selection you can select a suitable programme according to the type of utensils and degree of soiling. Information about comparability t...

  • Page 13

    En 13 * depending on model additional options can be set with the buttons h. Ÿ express wash * the >>express wash reduce the running time by approx. 20% to 50% depending on the selected rinse programme. To obtain optimum cleaning and drying results at a reduced running time, water and energy consumpt...

  • Page 14

    En 14 timer programming * * depending on model you can delay the start of the programme by 3, 6 or 9 hours. – switch on on/off switch (. – keep pressing the preselected starting time button @ until the appropriate display 3h, 6h or 9h is lit. – press start button 8, timer programming is activated. –...

  • Page 15

    En 15 a regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine – check spray arm for grease and limescale deposits. If you find such deposits: – fill detergent dispenser with detergent. Start the applian...

  • Page 16

    En 16 spray arm limescale and dirt from the rinsing water may block nozzles and the bearing assemblies of the spray arm 1". – check outlet nozzles on the spray arm for blockages. – remove the spray arm upwards. – clean the spray arm under running water. – lock the spray arm into position. Waste wate...

  • Page 17

    En 17 the majority of faults which could occur in daily operation can be rectified by the user. This ensures that the appliance is quickly available for use again. The following overview will help you locating the causes and gives helpful advise to eliminate them. ã= warning don’t forget: repairs ma...

  • Page 18

    En 18 refill indicator for salt x and/or rinse- aid p is not lit. – refill indicator/s switched off. – adequate salt/rinse-aid available. Refill indicator for special salt x is lit. – no salt. Refill with special salt. – sensor does not detect salt tablets. Use different special salt. ... During the...

  • Page 19

    En 19 if the advice given does not resolve your problem, please contact your customer service. Contact details can be found on the back cover of this instruction manual or in the enclosed customer service list. When calling , please quote the appliance number (1) and the production date (fd = 2) whi...

  • Page 20

    En 20 – some models: the plastic housing on the water connection contains an electric valve, the connecting cables are in the supply hose. Do not cut through this hose, do not immerse the plastic housing in water. Delivery your dishwasher has been checked thoroughly in the factory to ensure that it ...

  • Page 21

    En 21 removing the appliance also observe the sequence of worksteps here. – disconnect the appliance from the power supply. – turn off the water supply. – disconnect the waste water and fresh water connections. – pull out the appliance, carefully pulling the hose behind. Transportation empty the dis...

  • Page 22

    Childproof lock (door lock)* to open the door, move lever to right and pull door handle. Always close the appliance door completely when you leave the appliance. This is the only way you can protect your children from potential dangers..

  • Page 23: Aqua-Stop Guarantee

    If your appliance is fitted with aqua-stop, you can leave your appliance unattended during operation and leave the tap turned on afterwards. The tap should only be turned off if you are absent from home for a prolonged period, e.G. Several weeks holiday. A prerequisite for the warranty claim is that...