Balboa Water Group 2374 Owner's Manual
Page 1
BALBOA WATER GROUP
OWNER’S MANUAL
200 Series Electronic Hydromassage
™ Pumps
SAFETY INSTRUCTIONS:
An earth leakage or residual current protection divide must be fitted to all instructions.
t
Should the installer or
owner be unfamiliar with the correct installation or operation of this type of equipment, you should contact the
distributor/manufacturer for the correct advice before proceeding with the installation or operation of this product.
To reduce the risk of injury, do not permit children or persons with reduced physical, sensory or mental capabilities,
t
or lack of experience and knowledge to use this product unless they are closely supervised at all times by a person
responsible for their safety.
TABLE OF CONTENTS:
TECHNICAL INFORMATION .........................................................................................................................................1
t
INSTALLATION
t
............................................................................................................................................................3-4
OPERATION
t
...............................................................................................................................................................5-6
TROUBLESHOOTING
t
.................................................................................................................................................6-7
PARTS LISTING
t
...............................................................................................................................................................8
WARRANTY ..............................................................................................................................................................9-12
t
CONTACT
t
......................................................................................................................................................................12
TECHNICAL INFORMATION
Balboa 200 Series Electronic Hydromassage Pumps
Models: 2374, 2394 and 2404 (Hot Pump Bathmaster)
Models: 2376, 2386, 2396 and 2406 (DR Pump without heater)
Models: 2377, 2387, 2397 and 2407 (DR Pump with heater)
The range of Balboa 200 Series Hydromassage Pumps have been designed specifically for spa bath (whirlpool spa)
applications giving maximum performance for the ultimate relaxing bath experience.
The Balboa Hydromassage Pumps provide excellent hydraulic performance in a compact and
extremely quiet design. Designed to circulate hot water in (whirlpool) spa baths, these pumps
incorporate a special internal design to ensure the pump self drains eliminating the build up of
unhygenic/stale water.
Inlet
40mm
Barrel
union
Outlet
40mm
Barrel
union
Maximum Total Head
237x = 10.3m
238x
=
12.0m
239x
=
13.5m
240x
=
14.5m
Maximum Ambient Temperature
55
o
C
Maximum Water Temperature
70
o
C *
(*capable of pumping 70
o
C, not recommended for spa bath applications)
HOT PUMPS
Primary Heating Temperature Cut-out
40
o
C
Secondary “Safety” Heater Cut-out
45
o
C
IP
Rating IPX5
Noise
65
dBa
@
1
metre
40665 Rev D Feb. 9, 2012