- DL manuals
- Baldor
- Portable Generator
- PC Series
- Operator's Manual
Baldor PC Series Operator's Manual
Summary of PC Series
Page 1
Operator's manual for your series 'pc' generator baldor generators 3815 oregon street, oshkosh wi 54902 telephone 236-4200 • fax 920-236-4219 form#: s-psg-002-09 effective date: 4/4/97 series 'pc' cover\msw'00 revision date: 5/30/03.
Page 2
Forward this manual contains the information you need to safely and efficiently operate your generator set. During the preparation of this manual every effort was made to ensure the accuracy of its contents. Do not operate this generator set until you carefully read this manual and understand the sa...
Page 3
♦ place protective covers and guards over the rotating parts, if rotating parts such as the drive shaft, pulley, belt, etc. Are left exposed, they are potentially hazardous. ♦ when cleaning, repairing or inspecting, make sure all moving parts have stopped. ♦ prior to working on the generator set, di...
Page 4
♦ know how to stop the engine quickly and understand the operation of all controls. ♦ never permit anyone to operate the generator set without proper instructions. ♦ never allow children to operate the generator set. ♦ children and pets must be kept away from the area of operation due to the possibi...
Page 5
♦ always treat the electrical circuits as if they were energized. ♦ disconnect all leads plugged into the unit prior to working on it. ♦ have the electrical circuits serviced only by qualified technicians. ♦ inspect wiring frequently and replace frayed, broken or poor leads. ♦ do not connect this un...
Page 6
○ ○ ○ ○ for gasoline or diesel powered generator sets ○ ○ ○ ○ ♦ check all fuel supply piping and their connections on a monthly basis for fuel leaks. ♦ use only approved piping and componentry in your fuel supply system. ♦ a professional, experienced technician should only install the fuel supply sy...
Page 7
Table of contents section page basic location information…………………………………………………………………………………………….1 basic connection information……………………………………………………………………………………..2 basic engine information………………………………………………………………………………………………..3 generator end maintenance……………………………………………………………………………………………..4 basic engine ...
Page 8
Location for best service from your portable generator set there are several factors which should be taken into consideration when choosing the best location in which to operate it: moisture: all electrical equipment should be protected from excessive moisture. Failure to do so will result in deteri...
Page 9
Connections wiring: use sufficiently large insulated wire to connect the generator set to the load. The gauge of the wire will depend largely on the distance, the permissible voltage drop, and the size and type of load. If you are not sure of the gauge wire needed for your application, consult a com...
Page 10
Engine information this operator's manual only covers basic day to day engine operating instructions. However, the engine manufacturer's manual is included with your generator set and should be referred to for any additional information you may need. Become familiar with and follow all the engine ma...
Page 11
Maintenance maintenance should only be performed on the generator set after the engine has stopped and the generator set has cooled down. The battery and spark plug should also be disconnected prior to performing maintenance. Generator end maintenance generator end maintenance consists of cleaning t...
Page 12
Adjustments: √ the engine should be checked for proper speed setting(s). √ adjust the engine speed to 3720 rpm's (62 hz) with no load applied to the generator set. Test all gfci receptacles on a monthly basis by pressing the test button on the receptacle and making sure that the gfci trips and elimi...
Page 13
As an alternative to draining the fuel from a gasoline engine, you can add a fuel stabilizer, such as "sta-bil" to minimize the formation of fuel gum deposits during storage (follow the manufacturer's directions). 2. Drain the used oil from the engine's crankcase and refill it with fresh, clean oil ...
Page 14: Service
Ordering parts when generator repair parts are needed, they may be obtained by calling the customer services department at baldor generators or the nearest local office of baldor electric motors and drives. Accurate information such as the following will assure that you receive accurate parts for yo...
Page 15
Operation prior to starting the unit: 1. Locate and set up the generator set in an open, dry, well ventilated and reasonably level location. Operating this unit in an area not suitable for it's proper use may cause damage to the unit, severe injury, or death. See "location information" section locat...
Page 16
3. Pull lightly on the recoil grip until you feel significant resistance, then pull sharply. Do not allow the recoil rope to 'snap' back into the recoil housing. Allow the recoil to gently rewind into the recoil housing. See your engine manual for instructions specific to your unit. If the engine do...
Page 17
Simple troubleshooting listed below are the more simple solutions to some of the more common problems that are reported to the service department at baldor generators. These troubleshooting solutions are meant to be an aid for a person who has minimal electrical knowledge and experience. More in- de...
Page 18
5. Loss of residual magnetism. Loss of residual magnetism will not allow the generator's excitation system to build up and thus the generator set will not produce any power. To 'flash' the generator set, (restore residual magnetism) follow these steps: preferred method a. With the generator set stop...
Page 19: Control Panel
Control panel for the pc25b and the pc30h a = circuitbreaker. This circuit breaker provides overload protection for the generator set. When tripped the circuit breaker plunger will extend out approximately 3/8". B= standard duplex receptacle. This is your standard household duplex receptacle, it is ...
Page 20: Control Panel
Control panel mah30 and the mav30 units a = nema 515r gfci duplex. This receptacle is a ground fault circuit interrupter duplex rated at 125 vac, 20 amps. This receptacle must be tested on a regular basis (monthly). B = standard duplex receptacle. This is your standard household duplex receptacle, i...
Page 21: Control Panel
Control panel pc40h, pc40b and pc50h units a = nema 515r gfci duplex. This receptacle is a ground fault circuit interrupter duplex rated at 125 vac, 20 amps. This receptacle must be tested on a regular basis (monthly). B = nema l530r receptacle. This is a 120vac, 30 amp twist-lock style receptacle. ...
Page 22: Control Panel
Control panel pc60h a = nema 515r gfci duplex. This receptacle is a ground fault circuit interrupter duplex rated at 125 vac, 20 amps. This receptacle must be tested on a regular basis (monthly). B = nema l530r receptacle. This is a 120vac, 30 amp twist-lock style receptacle. C = circuit breakers. T...
Page 23: Control Panel
Control panel pc90ve a = nema 515r gfci duplex. This receptacle is a ground fault circuit interrupter duplex rated at 125 vac, 15 amps. This receptacle must be tested on a regular basis (monthly). B = nema l530r receptacle. This is a 120vac, 30 amp twist-lock style receptacle. C = circuit breakers. ...
Page 24
Generator end componentry for pc25b, pc30h, mav30, and mah30 generator sets - 247 -.
Page 25: Parts Breakdown
Parts breakdown for pc25b & pc30h ref letter old part # new part # description a 46.10025d 61sa0019a02sp stator assembly b 66.00025 61ra0011a00 rotor assembly d 230.02020 10xn3124y12 bolt, rotor attaching e 230.04020 10xn3124y14 bolt, engine adaptor casting f 230.12010 84xn1032l10sp bolt, fan attach...
Page 26
Generator end componentry for pc40h, pc40b, pc50h, and pc90ve generator sets - 269 -.
Page 27: Parts Breakdown
Parts breakdown for pc40h, pc40b, pc50h, pc60h, and pc90ve units: ref letter old part # new part # description a consult factory consult factory stator assembly b 66.00045 61ra0013a00 rotor assembly for pc40h, pc40b, pc50h and pc50he b 66.00055 61ra0015a00 rotor assembly for pc60h units b 66.00075 6...
Page 28
Connection diagram pc30h.
Page 29
Connection diagram mah30 & mav30 - 22 -.
Page 30
Connection diagram pc40h, pc40b & pc50h - 23 -.
Page 31
Connection diagram pc60h - 24 -.
Page 32
Connection diagram pc90ve - 55 -.
Page 33
Limited warranty unless otherwise provided, baldor generators are warranted against defects in baldor workmanship and materials for a period of time as set forth in the warranty period chart on the following page. All warranty claims must be submitted to a baldor generator repair facility prior to t...
Page 34
Warranty period generator series labor* parts portable products (premier, powerchief, dg series, k series) 1 year 3 years towable products (ts) 1 year or 3,000 hours whichever comes first 3 years or 3,000 hours whichever comes first 3600 rpm standby systems (some ae models) 1 year or 1,000 hours whi...
Page 35
Limitations: baldor generators is not responsible for the repair of generators required because of normal wear, accident, misuse, abuse, improper installation, lack of maintenance, unauthorized modifications or improper storage. Normal wear: this warranty will not cover repair where normal use has e...
Page 36
California proposition 65 warning engine exhaust from this product contains chemicals known to the state of california to cause cancer, birth defects, and other reproductive harm. California proposition 65 warning diesel engine exhaust and some constituents are known to the state of california to ca...
Page 37
Service is just a phone call away: 800-872-7697 www.Baldor.Com/products/generators.Asp 3815 oregon street oshkosh wi 54902 phone: (920) 236-4200 fax: (920) 236-4219.