Baldwin Boxall M2120E Operating Instructions Manual - page 4
Issue 2
Page 4 of 8
M2120E Integrated Technical Specification
Rated output power
100V line 230V AC supply
120W 83 Ohms
THD 1 kHz rated output
Aux input 230V AC supply
Less than 0.5% typically 0.2%
Typical output power 1% THD
Aux input 230V AC supply
100V line 150W 66 Ohms
Low Z - 80W 4 Ohms
Low Z - 130W 2 Ohms
Output regulation (1 kHz 100V line)
Better than 1dB
Output voltages obtainable
(Pin selection)
100V & low impedance
Supply voltage AC
220 – 240V 50 – 60 Hz
Power consumption @ 230V
Quiescent
Rated output power @ 1kHz
18VA
300VA
Fuse protection
1 x AC supply 20 x 5mm
2 x DC (amplifier) auto blade type
1 x 24V DC output
1 x DC “Busy” open collector output
3.15A(T)
10A(F)
1A Self resetable
500mA Self resetable
Aux input phono stereo summed mono
Sensitivity
Frequency response – 3dB
Signal to noise ratio
100mV @ 20K Ohms
Better than 40 Hz – 20 kHz
Better than 80 dB
Tone controls
Bass
Treble
± 12 dB @ 100 Hz
± 12 dB @ 12 kHz
Universal input (line)
Sensitivity
Frequency response – 3dB
Signal to noise ratio
80mV @ 12K balanced
Better than 40 Hz – 18 kHz
Better than 70 dB
Universal input (Mic)
Sensitivity
600µV balanced
Input impedance
Without phantom power
With phantom power 20V
12k Ohms
660 Ohms
Frequency response – 3dB
Better than 40 Hz – 18 kHz
Common mode rejection ratio
50 Hz – 30 kHz
Better than 60 dB
Signal to noise ratio terminated 200 Ohms
Better than 60 dB
LED indicators
Output level indicator
5%, 25%, 50% & 100%
Terminations
AC supply input
Aux signal input
Universal input
Input Access
Loudspeaker output
3-pin DIN IEC 6A
2 x phono, stereo summed mono
3-pin XLR
6-pin screw terminal connector
4-pin Speakon connector
Fan assisted
No
Dimensions (mm) (D x W x H)
340 x 430 x 90
Weight 12
kg