Ballistic Linehaul R247 User Manual - page 19
Ballistic User Guide
2
MAIN FEATURES _____________________________ 4
Dual SIM
4
Auto idle
4
GETTING STARTED ___________________________ 5
Turning the phone on and off
5
Inserting Internal SIM - prior to installation
5
Inserting External SIM
5
Switching SIMs
5
Making calls
6
Receiving calls
6
Call Options
6
Sound options
8
Power off
8
Ignition Sense
8
Network Coverage
8
USING THE KEYPAD __________________________ 9
Function Keys
10
Navigation keys
10
Ready mode / Shortcut keys
10
Keypad
11
Icons
12
MENU MAP ________________________________ 13
CONTACTS _________________________________ 15
Contacts List
15
Adding a new entry
15
Speed dialling
16
Deleting entries
16
Copying entries
16
Contacts Statistic
16
TABLE OF CONTENTS
TABLE OF CONTENTS
Ballistic User Guide
Ballistic User Guide
36
37
LINEHAUL R247
7. Security Settings
These settings may vary per Service Provider
Ask for PIN
Asks for PIN on power up.
Network Barring
Limit calls for certain conditions: Outgoing, Incoming.
This is a password provided by your Service Provider.
SMS Barring
Set/change barring password and disable
outgoing messages. Default = 0000.
Change
passwords
Change PIN, security code, and network
passwords here.
Default Security Code = 000000
SMS barring and Call Barring are network
passwords.
Master Clear/
Reset
Restore will reset Settings to their defaults.
2009 model also included Cancelling Call
Diversion,Call Waiting and Caller ID.
Clear will delete User Data – Contacts on the
phone, Speed dials, Messages (other than those
stored in the Module or on the SIM), Statistics
(Call Register and Call Times) and Alarms.
Both options require the Security Code. Default
is 000000
SETTiNGS
SETTiNGS
8. Car Settings
Auto Answer
Set to auto answer or after 2 or 5 rings. Default is OFF.
Safety Timer
(requires wiring
to ignition)
Default is ON and set to 120 minutes.
(Options are 0,30,60,120,12 hours, Always on).
Choose the amount of time the phone remains on
when the ignition is turned off (will wait till after
acallisfinishedifphonewasinusewhenignition
was turned off).
Safety Timer requires that wiring was done
correctly to ignition.
Option of 12 hours applies to 2010 model only.
MicProfile
DefaultisProfile3(not2009model).Thisoption
changes mic gain and may be useful for noisy trucks.
(Usealowerprofilenumberforanoisiertruck).
SpeakerProfile
DefaultisProfile1.Thisoptionchangesspeaker
gain and may be useful for noisy trucks.
Entering the PuK
If the PIN has been entered incorrectly 3 times, the phone will then
ask for a PUK code before it can be used for other than Emergency
Calls. Contact your Service Provider for the PUK code, and enter on
thescreen.YouwillthenberequiredtosetanewPINandconfirmthe
PIN before being able to use the phone.
In the event that the phone is needed to make an Emergency Call,
press Cancel to get to the Emergency Calls only screen.
To get the Enter PUK screen back, just turn the phone off using the
END key and then power on again using SND or END key. Then enter
thePUK,thenewPIN,confirmthenewPINandthephoneisbackto
normal.