Service manual ac-n006r, ac-n006rh ac-t006r, ac-t006rh.
Roblem possible cause solution water leakage rubber plug at the rear plate of the machine is out of place. Water tube inside the machine is not in the place or broken. Water tube is of bad connection or broken. Put back the rubber plug. Check and reinstall or replace the water tube inside the machin...
Problem possible cause solution compressor works but the fan doesn’t. Bad connection of the wires. Fan motor breaks down. Fan motor capacitor breaks down. P.C. Board breaks down. Fan blade is stuck. Check and reconnect or replace. Check and replace. Check and replace. Check and replace. Fix it. Big ...
Problem possible cause solution suction temperature & suction pressure are too low. Room temperature is too low. Dusty evaporator. R.P.M. Of the fan motor is low. Air return of the evaporator is blocked. Air supply of the evaporator is blocked. Increase the room temperature. Clean the evaporator. In...
How to? Replacing the compressor take off the overload protector and wires of the compressor. Take off the suction and discharging tubes. Unfasten the screws on the compressor. Take off the accessories for the compressor. Replace the defect compressor with a new one. Re-install the accessories, wire...
Replacing the down motor ( for condenser) take off the front & rear plates of the machine. Unscrew the front & rear fixers for the condenser. Take off the rear fixer. Take off the funnel of the condenser. Take off the defect motor and replace it with a new one. Re-assemble the front & rear plates an...
Replacing the up motor capacitor (for evaporator) take off the rear plate of the unit. Unfasten the screws of the motor capacitor. Take off the motor capacitor and replace it with a new one. Re-install in the opposite steps. Replacing the fan blade of the evaporator take off the front & rear plates....
Replacing the microswitch take off the front and rear plates. Take off the wires for the micro switch. Take off the lever. Take off the micro switch. Replace the defect micro switch with a new one. Re-assemble in the opposite steps. Replacing the control panel take off the front & rear plates. Take ...
