Balluff BF-IDU02 Operating Manual

Summary of BF-IDU02

  • Page 1

    Bf-idu02 rfid-reader company addresses europe, germany, headquarter balluff gmbh schurwaldstraße 9 d-73765 neuhausen, germany argentina balluff argentina s.R.L. Echeverría 1050, 1st uf 2 1604 buenos aires - florida oeste australia balluff pty ltd. 18 malvern street bayswater, 3153 victoria brasil ba...

  • Page 2: Bf-Idu02

    Bf-idu02 rfid-reader operating guide purpose of the device the bf-idu02 device is intended to read and write "epc global class 1 gen2" compliant data carriers (so called tags) via country dependent uhf radio frequencies. Check that you have the right device variant this uhf system consists of a radi...

  • Page 3: Bf-Idu02

    Bf-idu02 rfid-reader connecting the device the device has to be connected to one of the head connectors "h1" .. "h4" of a balluff bis v control unit via standard 4-wire cable with m12 industry connectors. The control unit delivers power supply and controls the device over this connection. Make an ad...

  • Page 4: Bf-Idu02

    Bf-idu02 rfid-reader setup and operation the bf-idu02 device will operate when the bis v control unit receives read or write commands from the connected plc. See the manual of bis v control units for how to send commands to the control unit. The transmission power may be set up with service software...

  • Page 5

    Federal communications commission interference statement this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential ins...

  • Page 6

    Canada, industry canada (ic) notices this device complies with canada licence‐exempt rss standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired op...