Distributed modular i/o quick start guide for 4 port io-link master communication discr ete i/o discr ete i/o analog i/o output s specialty power power discrete i/o analog i/o valve manifold control rfid or specialty devices discrete i/o quick start guide bni004a bni eip-502-105-z015.
2 connect the distributed modular i/o master block 1 1. Using an m12 d-coded ethernet/ip cable, connect the block to the ethernet network. 2. Power up the block using 24vdc and a 7/8" 4pole connector wired according to the below diagram. 3. Set the ip address of the block using the pushbutton displa...
3 tell the controller about the device 2 1. Every controller will need to know three things about the device being connected over ethernet/ip: n the ip address of the block n where to look for the data (instance id) in the block n how much data is at the location (data length) 2. Setup the block in ...
4 confirm communication is established 3 it is important to confirm the device is talking to the controller; this can be done by verifying status lights on the block just below the aux power ports and just above the first m12 i/o ports. Troubleshooting tips: n some controllers require a power cycle ...
5 configure io-link ports for distributed modular i/o 4 once communication is established you now need to tell the device how it will be used for distributed modular i/o. Every port can be used for standard i/o and is defaulted to this configuration. To tell the master block to look for an io-link d...
6 reading the process data – inputs 5a it is important to note that every standard i/o on the block is setup as a freely configurable port. If the controller is programmed to look for an input and there is an input wired there, it will be an input. If the controller is programmed to fire an output, ...
7 reading the process data – outputs 5b it is important to note that every standard i/o on the block is setup as a freely configurable port. If the controller is programmed to look for an input and there is an input wired there, it will be an input. If the controller is programmed to fire an output,...
Additional resources - available on the web 6 networks.Balluff.Com usa balluff inc. 8125 holton drive florence, ky 41042 phone: (859) 727-2200 toll-fr ee: 1-800-543-8390 fax: (859) 727-4823 e-mail: balluff@balluf f.Com web: www .Balluff.Us mexico balluff de mexico s.A. De c.V anillo vial ii fray jun...
