Balluff MAN BAE PD-VS-011-01 Installation Manual - page 2
Balluff Touch-Panel PC
Balluff GmbH
Schurwaldstrasse 9
73765 Neuhausen a.d.F. Germany
Tel. +49 7158 173-0
Fax +49 7158 5010
balluff@balluff.de
www.balluff.com
- 2 -
BIOS-Einstellungen / BIOS-settings
Im Folgenden werden die für Sie wichtigsten BIOS-Einsteilungen er-
klärt. Bitte beachten Sie, dass das BIOS ein Spezial-BIOS für integrierte
Monitor- Lösung ist. Entsprechend kann es nach Änderungen der BIOS
Einstellungen vorkommen, dass Sie kein Bild mehr auf Ihrem Touch-
PC-Bildschirm sehen. Aus diesem Grund sollten nur erfahrene Anwen-
der Veränderungen am BIOS vornehmen. Ist das System verstellt,
gehen Sie wie folgt vor: Drücken Sie (auch wenn Sie kein Bild sehen)
auf einer angeschlossenen Tastatur
„Entf“, bis Sie sich sicher sind, dass
sie im BIOS sind. Dann drücken Sie F5, Enter, F10,
„Enter“. Das Sys-
tem startet neu und Sie sollten auf Ihrem internen Monitorwieder ein
Bild haben.
• Die wichtigen Grafikeinstellungen für die Nutzung des intern verbau-
ten Monitors im Folgenden:
• Advanced -> North Bridge LVDS Config Select
• LVDS Panel Config Select: Physikalische Auflösung des Panels
• eEDID Panel Option = [Enabled]
ln the following, the most important BIOS settings are explained. Please
note that the BIOS is a special BIOS for PC's with built-in display solu-
tions. Accordingly, it can occur after adjustments to the BIOS that you
see no image on your monitor. For this reason, only experienced users
should make changes to the BIOS. lf the system is wrongly adjusted,
proceed as described in the following: press (even if you see no
image) on a connected keyboard the Delete key until you are sure you
are in the BIOS. Then press F5 Enter F10 Enter. The system will reboot
and you should have on internal monitor a gainer picture.
• The major graphic settings to use the touch PCs internal built in
monitor: Advanced -> North Bridge LVDS Config Select
• LVDS Panel Config Select: Physical resolution of the panel
• EDID Panel Option= [Enabled]
Fehlerbehebung / Troubleshooting
1. Kein Bild:
• Überprüfen Sie zunächst, ob die Stromversorgung korrekt ange-
schlossen ist und funktioniert (grüne LED am Netzteil).
• Bei Installation neuer Grafikkartentreiber wird unter Umständen das
BIOS verstellt und es ist kein Bootscreen zu sehen. Warten Sie eine
bis zwei Minuten, bis Windows geladen ist.
• Schließen Sie eine externe Tastatur per USB an und überprüfen Sie,
ob die Num-Lock LED der Tastatur leuchtet (drücken Sie Num-Lock).
Leuchtet diese, liegt in der Regel nur ein verstelltes BIOS vor. Machen
Sie den Rechner noch mal aus, starten Ihn neu und drücken Sie so
lange Entf bis Sie sicher sind, dass Sie im BIOS sind. Stellen Sie die
Grafikoptionen im BIOS gern. Kapitel BIOS-Einsteilungen neu ein.
• führt keiner der oben genannten Punkte zum Erfolg kontaktieren Sie
bitte den Hersteller.
2. Touch-Funktion ungenau
• Bitte führen Sie eine Rekalibrierung durch.
1. No picture
• First, check whether the power supply is properly connected and
working (green LED on the power supply).
• When you install new video card drivers, the BIOS is under certain
circumstances adjusted and there is no boot screen to see. Wait a
minute or two until Windows is loaded.
• Connect an external keyboard via USB and check whether the Num
Lock LED illuminates (press Num Lock on the keyboard). When it lits,
there is usually only a misaligned BIOS. Turn off the PC, reboot and
then press DELETE so often until you are sure that you are in the
BIOS. Set the graphics options in the BIOS following the Chapter BI-
OS settings.
• Ideas none of the above suggestions to success, please contact our
direct manufacturer service under the below shown contact infor-
mation.
2. Touch function is not exact
• Please do a recalibration to improve the exactness of the touch panel.
Technical Specification
CPU
Front Side Bus
RAM
HDD
BIOS
Graphic
Audio
Network
External Connectors
Input voltage
Operating temperature
Monitor and Touch-
Screen diagonal
(Inch/cm)
Display active screen
size:
Aspect ratio:
Touch life (contacts)
Response time
touch-panel (ms):
Surface hardness:
Mounting:
Brightness (cd/m2):
Contrast:
Colours displayed:
Visual Angle
horizontal, vertical (°):
Physical resolution
Intel® processor J1900 at 2.0 GHz/2.42 GHz
North/South Bridge: Intel® Nm10
4GByte
64GByte mSATA SSD
SM BIOS, ACPI 3.06
Intel HD graphics; DirectX 11.1, OpenGL 4.0
Realtek 887
8channel high definition audio codec Audio
Amplifier EUA 2012A
2 x Realtek PCIe Gb LAN 8111G
1x Display Port
1x VGA-out
1x USB 3.0, 3x USB 2.0 ports
2x COM port Full-
PIN (RS232/485; 5V/12V)
2x COM port 3-PIN
2× 10/100/1000Mbit RJ45 Ports
S/PDIF-Out (1x Cinch, 1x Torx)
MIC-In, EAR-Out
8x In/Out GPIO as RJ45
2x W-LAN-Antenna connectors
8-36V DC (screwable)
+10 °C to +40 °C
Panel Specification
12.1/30.73
24.6 x 18.4
4:3
unlimited
< 10
7H
VESA-100 holes
500
700:1
16.2M
160;160
1024×768
Nr./No
.
9
2
9
8
7
7
DE/EN
.
Au
s
g
a
b
e
/E
d
iti
o
n
J
1
7
; Än
d
e
ru
n
g
e
n
v
o
rb
e
h
a
lte
n
/S
u
b
je
c
t
to
m
o
d
ifi
c
a
ti
o
n
.
Er
s
e
tz
t/
Rep
la
c
e
s
E
17.