1. DL manuals
  2. Bally
  3. Freezer
  4. IM-268S-11
  5. Service Manual

Bally IM-268S-11 Service Manual

Manual is about: Walk-In Coolers And Freezer

Summary of IM-268S-11

  • Page 1

    Rev: 5/2013 im-268s-11 2013 © bally refrigerated boxes, inc. 1 service manual walk-in coolers and freezer im-268s-11 routine maintenance 2 safety walk strips 2 gaskets replacing magnetic gasket on hinged walk-in doors 3 replacing wiper gasket at bottom of hinged walk-in door 3 hinged walk-in doors r...

  • Page 2

    2 im-268s-11 2013 © bally refrigerated boxes, inc. Routine maintenance a. Keep all walkway surfaces clean and free of spilled liquids and food particles. B. Walk-in panels and magnetic door gasketing should be periodically wiped clean with a damp cloth. Use only mild soap to clean the panels: never ...

  • Page 3

    Rev: 5/2013 im-268s-11 2013 © bally refrigerated boxes, inc. 3 gaskets replacing magnetic door gasket on hinged walk-in doors a. Remove the old gasket and clean the surface where the new gasket will be placed. B. Position the new gasket, starting at the top corners. Tap it into place with a wood blo...

  • Page 4

    4 im-268s-11 2013 © bally refrigerated boxes, inc. Hinged walk-in doors replacing the d-1000 touch latch on walk-ins a. Remove the defective latch assembly. First remove the handle spring clip from under the handle at the back of the latch base, using a pair of needle-nose pliers. See figure 4. B. U...

  • Page 5

    Rev: 5/2013 im-268s-11 2013 © bally refrigerated boxes, inc. 5 replacing d-1250 spring-loaded hinges on walk-in door panels a. Close the door. Securely hold the door in place by shimming between the outside doorcap and the door frame. Remove the slotted machine screws from the hinge base and blade. ...

  • Page 6: Walk-In Doors

    6 im-268s-11 2013 © bally refrigerated boxes, inc. Anti-condensate heater replacing anti-condensate heater element around door frame of hinged walk-in doors a. Disconnect the outside power source leading to the door frame light junction box. Open the door 180 degrees. A large piece of cardboard can ...

  • Page 7

    Rev: 5/2013 im-268s-11 2013 © bally refrigerated boxes, inc. 7 reach-in doors replacing magnetic gasket on reach-in doors a. To replace the magnetic door gasket, it may be necessary to remove the door from the walk-in. Simply open the door and lift it off the hinge bases. Lay the door facedown on a ...

  • Page 8

    8 im-268s-11 2013 © bally refrigerated boxes, inc. Replacing hinges on reach-in door panels a. Close the door and shim the cap securely around the perimeter of the frame. Remove the slotted machine screws from the hinge base and blade. If tamperproof screws are used refer to figure. 5. Remove the de...

  • Page 9: Replacing Klixon On Prp

    Rev: 5/2013 im-268s-11 2013 © bally refrigerated boxes, inc. 9 pressure relief ports (prp) replacing magnetic gasket on prp a. Remove the port door by removing the screws from the poly-hinge at the top of the port door. See figure 14. B. Remove the interior plastic panel from the door by removing th...

  • Page 10: Replacing Door Closer

    10 im-268s-11 2013 © bally refrigerated boxes, inc. Replacing door closer a. Position a putty knife against the base of the bottom of the closer cover to protect the door surface as shown. See figure 17. Pry open the cover using a small flat bladed screw driver. The closer cover is friction fit onto...