Balt 89786 Assembly instructions manual - page 3
3
Diversity Stand
Assembly Diagram
P-7
Identify and Separate all the Parts and
Hardware.
Place the Shelf Platform (P7) with the insert
nuts facing up. Attach 1 each Left Leg
Receiver (P5) and 1 each Right Leg Re-
ceiver (P6) using 4 each (A) screws.
Attach 1 each Back Panel (P8) using 3
each (A) screws as shown in illustration #1.
(Finger tighten only)
Illustration # 1
Illustration # 2
P9
1.)
2.)
Attach Bottom Panel (P9) between
the Left Leg Receiver (P5) and Right
Leg Receiver (P6) using 7 Screws
(A) and 7 Square Nuts (B) as shown
in illustration #2.
3.)
A
P8
P6
R
EAD
T
HROUGH
I
NSTRUCTIONS
FROM
BEGINNING
TO
END
BEFORE
STARTING
TO
ASSEMBLE
UNIT
.
Do not use unless all screws are tight. At least
every six months, check all screws to be sure
they are tight. If parts are missing, broken,
damaged, or worn, stop use of the product
until repairs are made by your dealer using
factory authorized parts.
We recommend that you assemble this unit on a table.
4.)
(A) Screw M6 X 1/2”
For Scale only
P5
A
(B) Square Nut M6
For Scale only
A
B
P5
P6
B
P9
Attach 4 Locking casters (D) in the
front and back as shown in illustra-
tion #1. Tighten the Casters using
Caster Wrench (K).
5.)
D
D