Summary of BC-62
Page 1
Instruction manual.
Page 2
2 thank you for purchasing our bc-62 baby monitor. Your unit has been manufactured and checked under the strictest possible quality control to ensure that each monitor leaves the factory in perfect condition. If in the unlikely event you find any defects or have any problem, please contact your deal...
Page 3
3 warning the bc-62 baby monitor should not be regarded as a medical device. Premature babies or those considered to be at risk should be under the supervision of your doctor or health personnel. Direct supervision of your baby at a regular interval by a responsible adult is strongly recommended in ...
Page 4
4 power suppy (a) baby unit 1. Operation from batteries pr ess down the lock button and slide open the battery door in direction as shown. Insert three pieces aaa size (um-4) alkaline batteries into the compart - ment. Observe correct polarities indication. N.B. For best performance, do not mix use ...
Page 5
2. Charging up the lithium rechargable battery connect the output plug of the supplied 5v ac adapter to the usb port 22 of the unit, make sure the polarity is correct. With the parent unit being switched off, the power on icon 1 8 will start flashing red, indicating the battery is being charged. Onc...
Page 6
6 controls layout 7 8 6 1 11 2 4 18 19 17 13 14 16 15 22 20 21 5 3 12 9 10 baby unit parent unit 1 2 3 4 5 6 7 8 9 10 11 power on/off button microphone sensitivity down adjustment button microhone sensitivity up adjustment button night light intensity adjustment button night light vox control button...
Page 7
7 pairing this process is to match the parent unit with baby unit so that they can communicate with each other while no other devices (even baby monitor of identical model) can interfere with you or receiving your signal. The baby and parent unit are already paired with factory preset code when they...
Page 8
Operation baby unit 1. Long press the power on/off button 1 for 3 sec to switch on the unit. The power on icon 7 should light up steady green. To turn off, long press the button 1 again. 2. Place the unit about 1 m from the crib with the microphone 11 facing towards the baby. 3. Adjust the microphon...
Page 9
3. Once it receives a signal from the baby unit, the visual level meter 17 will light up. The number of segments being lighted up vary along with the sound. This feature is useful in case the parents prefer to turn down the speaker volume to keep the environment quiet. 4. The speaker volume can be a...
Page 10
Use only the supplied ac adapters, use of other adapters may cause damage to 10 standard accessories a. 5v ac adapter x 2 b. Baby unit c. Parent unit d. 3.7v li polymer rechargeable battery pack (installed in parent unit) e. User manual a b d e c precautions - the bc-62 baby monitor. - when not usin...
Page 11
Trouble shooting guide 11 problem baby unit has no transmission transmission always on out-of-range alarm always on always showing low battery alert battery life is short communication frequently interrupted too short communication range possible cause - mic sensitivity is too low - battery has run ...
Page 12
12 all european countries except austria, georgia, greece, norway, russian, federation, spain, sweden, the netheriands, ukaine..
Page 13
13.
Page 14
Fcc caution: the user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to...