Bambino Elite Isofix Instruction Manual - page 11
page 10
Converting for groups II+III [15-36kg]
It is recommended that you use the 5-point harness for as long as possible. If you remove
the booster cushion this could allow you to use the seat in group l configuration for longer.
A
B
C
Pull the recline adjuster handle under
the front of the shell and whilst holding it,
pull the shell forwards to its most reclined
position.
Release catch (D) on the top left
hand side of the shell and remove the
installation bar (E).
D
E
When your child has outgrown the group
I(9-18kg) configuration and you wish to
use the seat for a child in either
group II (15 - 25kg) or group III (22-36kg)
then you will need to remove the child
car seats integral 5-point harness.
Lift the fabric adjuster cover at the
front of the car seat and whilst pressing
button (A), pull forwards on the shoulder
straps (not the shoulder pads) to
completely loosen the harness straps
and shorten the adjuster strap (B) as
much as possible. Any remaining strap
can be rolled up and stored under the
red plastic cover (C).
IMPORTANT: DO NOT pull the shoulder
pads.
Note: the “Elite Isofix” must be used with Isofix anchors and top tether at the same
time with 3-point automatic seat belt for group Ⅱ/Ⅲ at all times.