Banana Pi BPI-D1 Quick Start Manual - page 6
1.WiFi OFF, BPi-D1 is recording and saved to TF card, current 5V power is about 250mA.
2.WiFi ON, BPi-D1 is recording and saved to TF card, at the same time D1S connected to the network
through WiFi
,
current 5V power is about 350mA.
3.It can be used to predict 500mah lithium batteries can maintain BPi-D1 work 1 to 2 hours.
Program the Firmware
Important Notes before You Start:
1.You must use the compatible version of the firmware programing software with source codes.
2.The software works on Windows XP Service Pack 3 and newer versions.
3.The software file path is located at: /lamobo.dev/tool/burntool in the code directory
4.Before programing the firmware, please make sure to copy and paste the 3 compiled files “zImage,”
“root.sqsh4,” and “root.jffs2” to the root directory.
(Note: The complied files are saved at: /lamobo.dev/output)
How to Program the Firmware
1.Battery mode, press and hold the "primary key" 5 seconds off BPI-D1 power. Before the PC inserts
BPI-D1 micro - USB programming cable, double-click firm programming tools icon, runs the burn
tool. Holding down the "function key" and the micro - USB programming cable connecting to the PC,
the module enters the programming mode. At this time BPI-D1 LED no instructions. If there is no
lithium battery, you do not need to connect the micro USB power cable.