Bandit HY-100 User manual - page 12
SET
11/42
END
2.2 Scanning mode selection
Trigger mode:
The scanner becomes inactive as
soon as the data is transmitted. It must
be triggered to become active again.
Auto scan mode:
The scanner is always on, put the barcode before the scan line, decode just one time. Decode
again only when change barcode. If decode the same barcode once more, put it on the scan line,
then scan works the second time.
Alternate mode:
When press the scanner trigger switch once, this scanner will light up. Simultaneously, The
scanner decoded only once when put the barcode on the scan line. If put the barcode on the scan
line again, the scanner decoded again. Then, the scanner will turn off for next pressing.
Repeat mode:
This mode is similar to Auto scan mode, but double reading for the same barcode is
prohibited if the scanner switch is pressed.
Testing mode:
The scanner is always on. All the while, the scanner decoded and transmitted the data
when the barcode is put on scan line.
Turbo trigger mode:
When the trigger is pressed, the scanner decoded sequentially.
ITEM OPTION
None ( Default )
RTS/CTS
ACK/NAK
HANDSHAKING
SELECTION
Xon/Xoff
300 ms
800 ms
( Default )
1500 ms
RESPONSE TIME
5000 ms