Bang & Olufsen beocom 1401 User Manual
BeoCom 1401
RINGING SIGNAL
BeoCom 1401 has 10 different settings
for the ringing signal, consisting of 3
levels, 3 melodies and the ringing signal
disconnected.
SETTING THE RINGING SIGNAL
Press
Enter
Press
Press
0-9 to select a setting
Press
Enter
When the ringing signal is disconnected
(setting 0), it is automatically
reconnected the first time you lift off
the handset and place it in the base
again.
ADJUSTING THE VOLUME
During a call, you can adjust the
handset volume in 5 steps by pressing
the
+
and
–
buttons. All calls start at
the medium volume level.
Press
+
to increase the volume
Press
–
to decrease the volume
REDIALLING
Press
Rdl to redial the last number
called
Numbers with up to 31 digits can be
memorized.
Numbers stored in memory cannot be
called by pressing Rdl.
In order to ensure that the last
number called is stored correctly in
the memory of BeoCom 1401 and can
be redialled by pressing Rdl, the
handset must have been placed in
the base (or the switch off key on the
bottom side of the handset pressed)
for at least 1 second.
MICROPHONE
Press
to mute the
microphone
A beeping signal in the handset
indicates that the microphone is
muted.
Press
to connect the
microphone
Please note! Pressing any other key
once or twice will connect the micro-
phone as well.
MEMORY
BeoCom 1401 memorizes 10 tele-
phone numbers which can be stored
with code numbers from 0 to 9.
Numbers of up to 21 digits can be
memorized.
If the telephone line is disconnected
for more than 1 hour, numbers
stored in the memory will be deleted.
This may also happen when using a
computer modem or another
telephone on the same line.
STORING PHONE NUMBERS
Press
Enter
Press
Mem
Enter
the code number (0-9)
Enter
the phone number
Press
Enter
DIALLING A STORED NUMBER
Press
Mem
Enter
the code number (0-9)
DELETING A STORED NUMBER
A stored number is deleted by
storing a new number with the same
code number.
SWITCHBOARD
STORING PHONE NUMBERS
Press
Enter
Press
Mem
Enter
the code number (0-9)
Enter
the phone number
Press
Enter
DIALLING A STORED NUMBER
Press
the prefix
Press
Mem
Enter
the code number (0-9)
REDIALLING A NUMBER
Press
the prefix
Press
Rdl
If the R-button is used for recalls,
subsequent entries will not be stored
for redialling.
Please note!
The R/Flash-button may also be
referred to in some instances as the
Recall-button.
Slow
Normal
Fast
Disconnected
Low
1
4
7
0
Medium
2
5
8
High
3
6
9
Beocom
Beocom
2
5
8
0
Vol
3
6
9
Mem
Enter
ABC
DEF
GHI
PQRS
JKL
TUV
MNO
WXYZ
1
4
R
Rdl
Vol
7
Flash