Summary of BeoLab 10
Page 1
Beolab 10 guide.
Page 2
Cautions! – make sure that the loudspeaker is placed and connected in accordance with the instructions in this guide. To prevent injury, use bang & olufsen approved stands and wall brackets only! – the loudspeaker can only be switched off completely by disconnecting it from the wall socket. – do not...
Page 3
Daily use when you have finished setting up the loudspeaker as described on the following pages, connect the entire system to the mains. Loudspeaker protection the loudspeaker is equipped with a thermal protection system which prevents damage from overheating. If an error occurs – or the speaker uni...
Page 4
Set up the loudspeaker – cable connections the loudspeaker socket panel is located on the rear. Insert the cables and set the position switch before you fasten the loudspeaker to the wall bracket. For information about the sockets on the bang & olufsen system, refer to the guides enclosed with the p...
Page 5
The position switch when a loudspeaker is placed in a corner or close to a wall, the bass level is boosted compared to the bass level from a loudspeaker placed in a more free-standing position. To remove this excessive bass boost, use the position switch to ensure that the bass level suits the place...
Page 6
Set up the loudspeaker – wall bracket the wall bracket must be fastened to the wall so that the loudspeaker is placed in a centred position immediately below the television screen. We recommend that you place the television screen so that the loud speaker will be at least 10 cm (4") above the floor...
Page 7
To fasten the wall bracket 1 fold the cardboard ‘tool’ as shown, and attach it to the wall bracket. 2 hold the wall bracket against the wall – centred below the tele vision screen. Make sure that the ‘tool’ touches the screen edge. 3 mark up on the wall where to drill the holes. 4 drill the holes i...
Page 8
>> set up the loudspeaker – wall bracket to fasten the loudspeaker attach the television screen and loudspeaker cables to the wall bracket before you fasten the loud speaker. Use the small cable clamps provided. – connect the cables to the loud speaker and hang it on the wall bracket by inserting ...
Page 9
To attach the loudspeaker front panel 1 insert all the little pegs on the rear side of the panel into the corresponding holes in the loud speaker cabinet. 2 make sure that all the pegs are firmly seated into the holes. When finished, the loudspeaker front panel must be aligned with the front of the...
Page 10
The european parliament and the council of the european union have issued the waste electrical and electronic equipment directive. The purpose of the directive is the prevention of waste of electrical and electronic equipment, and to promote the reuse and recycling and other forms of recovery of suc...
Page 11
For the canadian market only! This class b digital apparatus meets all requirements of the canadian interferencecausing equipment regulations. This product is in conformity with the provisions of the directives 1999/5/ec and 2006/95/ec. Technical specifications, features and the use thereof are sub...
Page 12
Www.Bang-olufsen.Com 3509664 0802.