Bang & Olufsen BeoLab 4 PC Manual - page 3
Daily use
When you have finished setting
up the loudspeakers as described
on the following pages, connect
the entire system to the mains.
Cleaning the loudspeaker
You can clean the speaker panels
with a vacuum cleaner set to the
lowest suction level. Clean the other
surfaces using a soft, lint-free cloth
which you have dipped in lukewarm
water and wrung firmly.
Never use alcohol or other solvents
to clean any parts of the loud-
speaker!
Switching on and off
If you have set the LINE IN MODE
switch to AUTO, the loudspeakers
automatically switch on when they
receive an input signal – indicated
by green indicator lights. When you
switch off your system, the loud-
speakers will, after a few minutes,
automatically switch to standby –
indicated by red indicator lights.
However, if you have set the LINE IN
MODE switch to ON, the loud-
speakers are always switched on,
even when you switch off your
system.
In either setting of the LINE IN
MODE switch, the loudspeakers can
only be switched off completely by
disconnecting them from the mains
supply.
3
NOTE! Prolonged listening at high
volume levels may cause hearing
damage.
Indicator light