Bang & Olufsen BeoLab 4 PC Manual - page 4
Set up the loudspeakers
We recommend that you follow
this procedure:
– Disconnect your system from the
mains.
– Connect the loudspeakers and
set the LINE IN MODE switch on
each loudspeaker as explained in
‘Cable connections’
(pp. 6–7).
– Connect the entire system to the
mains again.
The loudspeaker must be placed
standing upright on its base, or
fastened to one of the optional
accessories. Make the connections,
and set the switch before you
fasten the loudspeaker to one of the
accessories.
Cautions
– Make sure that the loudspeakers
are placed and connected in
accordance with the instructions
in this Guide. To prevent injury,
use Bang & Olufsen approved
stands and wall brackets only!
– Do not attempt to open the
loudspeakers. Leave such
operations to qualified service
personnel! The speaker panels,
however, may be removed for
cleaning.
– The loudspeaker is designed for
indoor use in dry, domestic
environments only, and for use
within a temperature range of
10–40º C (50–105º F).
– For optimum sound quality,
do not place the loudspeaker
enclosed in, for example, a small
bookcase. Leave a minimum of
20 cm (8") free space at the sides,
and never place anything directly
in front of the loudspeaker.
– Do not block the sound emitting
from the bass reflex port at the
bottom of the loudspeaker.
– Place the loudspeaker with its
front (the Bang & Olufsen name
plate) facing your favourite
listening position.
4