Bang & Olufsen BeoLab 5 User Manual - page 5
5
Use BeoLab 5 with a non-Bang &
Olufsen system
The loudspeakers must be connected as
explained on page 10, and the Option number
set to 1 or 4, as explained on page 11.
Operate your non-Bang & Olufsen system as you
normally would. However, you will have to use a
Beo4 remote control (optional accessory) to do the
following:
– Switch the loudspeakers on and off;
– Turn the volume level up or down;
– Adjust the left–right sound balance (when you
switch on the loudspeakers, the balance is
always neutral);
– Store and reset sound levels;
– Use the PIN code system;
– Change Option setting and LINE input level.
Although BASS, TREBLE, LOUDNSS are available in
the Beo4 display you cannot adjust these levels
using Beo4. We recommend that you keep any
tone control settings neutral.
For specific information about the Beo4 remote
control, please refer to its enclosed Guide.
Option 1
Option 4
If BeoLab 5 is programmed to Option 1
To switch BeoLab 5 on/off…
> Press RADIO to switch on.
> Press • to switch off.
To turn the volume level up/down…
> Press
∧ to turn the volume up.
> Press
∨ to turn the volume down.
To reset the sound level…
> Press LIST until RESET* is shown in the Beo4
display.
> Press GO to reset sound level.
To shift the left–right sound balance…
> Press
ss
to shift the sound towards the left, and
press
tt
to shift the sound towards the right.
To store a new start up sound level…
> Press
∧ ∨ until you reach your preferred start
up sound level.
> Press LIST until A.SETUP* is shown in the Beo4
display.
> Press GO to accept.
> Press LIST until S.STORE is shown in the Beo4
display.
> Press GO to store the new start up level.
If BeoLab 5 is programmed to Option 4
To switch BeoLab 5 on/off…
> Press LIST until LINK* is shown in the Beo4
display, and then RADIO to switch on.
> Press • to switch off.
To turn the volume level up/down…
> Press
∧ to turn the volume up.
> Press
∨ to turn the volume down.
To reset the sound level…
> Press LIST until RESET* is shown in the Beo4
display.
> Press GO to reset sound level.
To shift the left–right sound balance…
> Press
ss
to shift the sound towards the left,
press
tt
to shift the sound towards the right.
To store a new start up sound level…
> Press
∧ ∨ until you reach your preferred start
up sound level.
> Press LIST until A.SETUP* is shown in the Beo4
display.
> Press GO to accept.
> Press LIST until S.STORE is shown in the Beo4
display.
> Press GO to store the new start up level.
*Must be added to the Beo4 LIST-function. To do
so, refer to the Beo4 Guide.
BEOLAB 5 GUIDE Pi
d GB 3506377 1 SEKUNDA