Guide beolab 7-4.
Cautions! – make sure that the loudspeaker is placed and connected in accordance with the instructions in this guide. To prevent injury, use bang & olufsen approved stands and wall brackets only! – the loudspeaker can only be switched off completely by disconnecting it from the wall socket. – do not...
Daily use when you have fi nished setting up the loud speaker as described on the following pages, connect the entire system to the mains. Loudspeaker protection the loud speaker is equipped with a thermal protection system which prevents damage from overheating. If an error occurs – or the speaker ...
Set up the loudspeaker we recommend that you follow this procedure: – disconnect your bang & olufsen system from the mains. – mount the loudspeaker to the bang & olufsen stand or wall bracket as explained on the next page. – connect the loudspeaker as explained in ‘cable connections’ (pp. 6–7). – se...
Here is shown how to fasten the loud speaker with a ‘ type 1 bracket’ to a bang & olufsen ‘single-column’ stand (or wall bracket). Use the same procedure if you wish to fasten the loud- speaker to a bang & olufsen ‘double-column’ stand – with a ‘ type 2 bracket’ . A remove the small cover (if any) o...
Cable connections the loudspeaker is primarily intended to be used in a surround sound setup with beovision 7*. It may, how ever, be used with other bang & olufsen systems as well – for example in a beovision 4 surround sound setup. If used in a setup not including beovision 7, you will require a ma...
Connection to other bang & olufsen systems … use a power link cable of the correct type to connect the loud- speaker to a power link socket on the bang & olufsen system. For further information, refer to the guide enclosed with the bang & olufsen system. Power link cable: do not use a cable of the o...
Adapt the loudspeaker to your room when a loudspeaker is placed in a corner or close to a wall, the bass level is boosted compared to the bass level from a loudspeaker placed in a more free-standing position. To remove this excessive bass boost, use the position switch to ensure that the bass level ...
The position switch is located on the loud speaker socket panel. How to measure: the distance is measured as shown here – the loud- speaker seen from above. F w 9.
To get access to the approval labels, remove the loudspeaker front grill: push the front grill downwards until stop (~ 10 cm/4"). The front grill can now be removed. Note: when attaching the front grill again, first insert the centre peg into the bottom end of the groove (a), and move the front gril...
For the canadian market only! This class b digital apparatus meets all require ments of the canadian interference-causing equipment regulations. This product fulfils the conditions stated in the eeu directives 89/336 and 73/23. Technical specifications, features and the use thereof are subject to ch...
Www.Bang-olufsen.Com.
