Summary of BeoLab 9
Page 1
Beolab 9 guide.
Page 2
Warning: to reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not expose this equipment to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the equipment. To completely disconnect this equipment from the ...
Page 3
Contents daily use, 4 information about how to use the loudspeakers, about the built-in protection system, and how to clean the loudspeakers. Set up the loudspeakers, 5 important information to consider before setting up the loudspeakers. Cable connections, 6 information about the sockets, switches,...
Page 4
Daily use when you have finished setting up the loudspeakers as described on the following pages, connect the entire system to the mains supply. The indicators light up in red, indicating that the loudspeakers are in standby, ready to be used. The loudspeakers are designed to be left in standby mode...
Page 5
Set up the loudspeakers we recommend that you follow this procedure when you set up the loudspeakers: – disconnect your system from the mains supply. – connect your loudspeakers and set the switch marked line–right–left on each loudspeaker as explained in ‘cable connections’ (pp. 6–7). – set the swi...
Page 6
Cable connections the loudspeakers can be used with bang & olufsen audio, video and link systems. They may also be connected to non-bang & olufsen systems. For specific information about the sockets on your system, refer to the guide enclosed with the system. Connection panel free–wall–corner switch...
Page 7
Securing the cables: for safety reasons, the mains lead must be fastened to the loudspeaker. To do so, tug the mains lead behind the small bracket on the connection panel. Then run all cables behind the clamp, and tighten the two screws. Cover for the connection panel: to remove the cover, grip it a...
Page 8
Adapt the loudspeakers to your room the loudspeakers may be placed almost anywhere in you room. However, the most natural sound is obtained if they are set up as explained on these pages. The acoustic lens technology system ensures better balance in the high tone frequencies coming directly from eac...
Page 9
If you have a beolab 2 subwoofer setup … as explained in the beolab 2 guide, the subwoofer has a setup switch which can be set to 1 , 2 or 3 . The settings of this switch will adapt the output from beolab 2 to the sensitivity levels of different loudspeakers. If you set up a pair of beolab 9 loudspe...
Page 10
Waste electrical and electronic equipment (weee) – environmental protection the european parliament and the council of the european union have issued the waste electrical and electronic equipment directive. The purpose of the directive is the prevention of waste of electrical and electronic equipmen...
Page 11
This product fulfils the conditions stated in the eeu directives 89/336 and 73/23. For the us-market only! Note: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable prot...
Page 12
Www.Bang-olufsen.Com.