Bang & Olufsen BeoSound Shape Installation Manual - page 17
Software update - Web Interface 17
Software update
Software can be checked and updated via the Bang & Olufsen app.
Automatic software update
Is per default (factory reset) set to On and can be set to Off (not recommendable).
A check for new updates are made every night (local time) somewhere between T00:00 and T06:00 and takes only place if automatic update is set
to On, and if BeoSound Shape is in Standby mode.
In the following setups, it may be relevant to set automatic update to Off: - Hotels; - Retailers; - Home Automation setup; and - test environments,
as if an update takes place either in BeoSound Shape or in another network link product all other network link products will then ask if they should
also be updated. This may be unlikely in certain situations. If automatic SW update is set to Off, then check for updates regularly, when ready to
take updates.
Web interface access to the BeoSound Shape
You can get access to the Web interface via the Bang & Olufsen app or by using a computer.
Using a computer the BeoSound Shape must be connected by a LAN cable to the home router/AP and the computer must likewise be connected
to the home router/AP either by a LAN cable or wirelessly. Hand held
devices with a web browser may also be used and connected to the
home router/AP.
The hand held device/computer gets access to the Web server using a
web-browser (Google Chrome or Safari) and in the address field enter:
http://< BeoSound Shape IP address>, where
-
router.
The
program, either "Discover digital networks" or "Fing".