Bang & Olufsen BeoSystem 3 User Manual - page 24
First-time setup of your television
Tuner setup
Connections
If you select CABLE BOX, follow the on-screen information to specify which
cable box you have connected to the TV. If you select ANTENNA or CABLE, a
scanning process begins when you store the setting. See the Guide for further
information.
Select the type of equipment connected to each socket, the sockets used, the
product name, and the source name.
Information
This first-time setup procedure is activated when the TV is connected to the mains
and switched on for the first time. If you want to change your setup at a later date,
you can access the same menus and update your settings.
Switch on the TV
Select settings
You are led through the following settings only
when you switch on the TV for the first time.*
1
However, the sequence of menus depend on the
connections and settings you make.
It takes the TV approx. 20 seconds to start up and
become ready for use.
Switch on
Select setting
Accept and go to next menu item
Disable or enable the navigation button on your remote control*
2
Disable or enable internal TV tuner or ATSC
Register connected equipment
1
*NOTE! When you have selected the preferred
settings in a menu, you may have to press the
green
button to continue to the next menu in the
first-time setup procedure. Follow on-screen
instructions.
or
TV
REMOTE CONTROL
TUNER SETUP
CONNECTIONS
24