Banks monster ® exhaust system 2008 ford 6.8l (v-10) & 2011 ford 6.2l (v-8) crew cab short (6.75ft) bed f-250/f-350 super duty this manual is for use with monster exhaust systems 48725 owner’smanual with installation instructions.
2 96524 v.3.0 general installation practices 1. Before starting work, familiarize yourself with the installation procedure by reading all of the instructions. 2. The exploded view (figure 1) provides only general guidance. Refer to each step and section diagram in this manual for proper instruction....
96524 v.3.0 3 fa ct or y intermedia te pipe 1 2 3 4 5 6 7 figure 1 general assembly diagram item # description part # qty 1 hanger clamp , intermediate 53144 1 2 intermediate pipe 53143 1 3 hanger clamp , f ront muffler 53145 1 4 monster 3.5” muffler 54008 1 5 hanger clamp , rear 53146 1 6 tailpipe ...
4 96524 v.3.0 1. Disconnect the negative (ground) cable from the battery (if there is more than one battery, disconnect both negative cables). Secure the cable so it cannot accidentally come in contact with the post. 2. Raise the vehicle and support it securely with properly weight-rated safety stan...
96524 v.3.0 5 2008 ford 6.8l v-10 super duty & 2011 ford 6.2l v-8 super duty wheel base cut this length from the intermediate pipe. See figure 2. Super cab/ short bed 142” 31.75” crew cab/ short bed 156” 16.25” crew cab/ long bed 172” no cut table 1 5. Locate the supplied intermediate pipe and cut t...
6 96524 v.3.0 figure 4.
96524 v.3.0 7 rear hanger banks monster tip 3/4" - 1" banks tailpipe forward figure 5 9. From the vehicle rear, route the tailpipe over the rear end. Start the tailpipe hanger pin into the corresponding vehicle rubber hanger. Install the tailpipe into the banks muffler outlet. Lightly tighten the re...
Figure 7 figure 6 placement of template on passenger side rear undercarriage lining. Banks power performance exhaust exhaust systems.
