Operating instructions ez27 roll laminator revised october 2, 2003.
Table of contents safety messages and electrical safeguards .................................. 1-2 introduction ...................................................................................... 2-3 laminator features ............................................................................ 3...
Important safety messages and electrical safeguards for your protection, do not connect the laminator to electrical power or attempt to operate it until you read these instructions completely. Keep these instructions in a convenient location for future reference. This instruction manual and labels a...
Unplug the laminator before moving it or when it is not in use for an extended period of time as a precaution against the possibility of an internal malfunction that could create a fire hazard. Do not operate the laminator with a damaged power supply cord or plug, or after it malfunctions or has bee...
Your ez27 is preset at the factory for most applications so any adjustments should be minor. A thermometer provides continual indication of the heat shoe temperature and may be adjusted as needed. Laminator standard features... Preset laminating roller pressure and speed require no adjustment. Feed ...
Initial setup unpacking and assembly... Before unpacking the unit, inspect the shipping container for signs of damage. Notify the carrier and your dealer immediately if any damage is noted. Caution! The laminator, without the feed table and mounting slides installed, weighs approxi- mately 70 lbs. U...
Machine drive: this three position (fwd/off/rev) switch controls power to the laminating rollers. If the switch is pressed to the fwd position the rollers move forward, pulling the plastic film and laminated material past the heat shoes. When this switch is pressed to the rev position the rollers mo...
Threading laminating film... These instructions apply to poly-in film rolls (shiny side out, dull side in) 1. For the top supply roll place the mandrel ends into the slots in the top of the laminator. If you are facing the front of the laminator the film should unwind toward you from the bottom of t...
5. Turn the machine drive switch to fwd to start the laminating and pull rollers. 6. Feed a piece of thin cardboard about 10” x 25” against the film so that it is centered between the two heat shoes. Push the cardboard and film into the laminating rollers. See figure 5. 7. When the feed card has com...
Setting heat shoe temperature... The laminator temperature should be adjusted according to the film thickness and the item being laminated. See table 1 below for recommended temperature settings. Keep in mind that the temperatures listed are approximate and different brands of laminating film may re...
