1. DL manuals
  2. Banner
  3. Network Router
  4. Sure Cross DX70
  5. Instruction Manual

Banner Sure Cross DX70 Instruction Manual - Contents

Manual is about: Wireless Point-to-Point kits

Summary of Sure Cross DX70

  • Page 1

    Sure cross ® dx70 wireless point- to-point kits instruction manual original instructions 133214 rev. L 2 march 2016 133214.

  • Page 2: Contents

    Contents 1 dx70 point-to-point radios ........................................................................................... 3 1.1 device components ...................................................................................................................4 2 setting up and installing a...

  • Page 3: 1 Dx70 Point-to-Point Radios

    1 dx70 point-to-point radios the sure cross ® dx70 wireless series consists of a radio frequency network built around two devices and configured i/o that operates in most environments and eliminates the need for wiring runs.. • wireless industrial i/o system with discrete (sourcing or sinking) input...

  • Page 4

    Replacement dx70 models kit models device frequency replacement dx70 model gateway dx70g2x6s4p8 1.1 device components 1 2 3 3 4 5 6 1. Rotary dials. After the dx70 devices are bound, use the rotary dials on the gateway to set the network id (nid) to a decimal value from 1 to 32. 2. Leds. Power led -...

  • Page 5: Network

    2 setting up and installing a dx70 point-to-point network to set up and install dx70 kits, follow these steps. These kits ship from the factory bound together and with their inputs and outputs mapped as shown in the i/o mapping tables. 1. Configure the gateway and node's dip switches (if necessary)....

  • Page 6

    Dip switch 3 discrete input type on npn 2.1.2 use input/output 1 or use link loss indicator (em1 kit only) the lost link indicator option is only available with the em1 kit. When dip switch 4 is off (default position), the link loss error indicator uses output 1 and input 1 is not available. When di...

  • Page 7

    Terminal label dx70 gateway dx70 node terminal label di1 discrete in 1* ---> discrete out 1 or lost link indicator* do1 di2 discrete in 2 ---> discrete out 2 do2 di3 discrete in 3 ---> discrete out 3 do3 di4 discrete in 4 ---> discrete out 4 do4 ai1 analog in 1 ---> analog out 1 ao1 ai2 analog in 2 ...

  • Page 8

    Terminal label dx70 gateway dx70 node terminal label do5 discrete out 5 discrete in 5 di5 do6 discrete out 6 discrete in 6 di6 do7 discrete out 7 discrete in 7 di7 do8 discrete out 8 discrete in 8 di8 2.2.2 sensor connections refer to the sensor device data sheet for a device specific wiring diagram...

  • Page 9

    Status power led signal led rf link good green solid amber flash binding mode red flash red flash successful binding red solid (for 3 seconds) red solid (for 3 seconds) if you are testing the devices before installing them, verify the devices are at least two meters apart to avoid over-driving the l...

  • Page 10

    Watertight glands and npt ports to make glands and plugs watertight, use ptfe tape and follow these steps. 1. Wrap four to eight passes of polytetrafluoroethylene (ptfe) tape around the threads as close as possible to the hexagonal body of the gland. 2. Manually thread the gland into the housing hol...

  • Page 11

    Increase the height of the antennas position the external antenna vertically for optimal rf communication. If necessary, consider changing the height of the surecross radio, or its antenna, to improve reception. For outdoor applications, mounting the antenna on top of a building or pole may help ach...

  • Page 12

    Figure 2. During spring and summer, leaves may block more of the radio signal. 2.4.4 basic remote antenna installation a remote antenna system is any antenna system where the antenna is not connected directly to the radio; coaxial cable connects the antenna to the radio. When installing a remote ant...

  • Page 13

    Weatherproof remote antenna installations seal the connections with rubber splicing tape and electrical tape to prevent water damage to the cable and connections. Step 1: verify both connections are clean and dry before connecting the antenna cable to the antenna or other cable. Hand-tighten the cab...

  • Page 14

    Models description list price bwa-9o2-d antenna, omni, 900 mhz, 2 dbd, dome, rp-sma male box mount, 18-inch antenna cable $95 bwa-2o2-d antenna, omni, 2.4 ghz, 2 dbd, dome, rp-sma male box mount, 18-inch antenna cable $95 sure cross ® dx70 wireless point-to-point kits 14 www.Bannerengineering.Com - ...

  • Page 15

    Use an n-type, pole-mounted antenna this antenna mounts remotely from the box, with the surecross device mounted inside the box. Ground the surge suppressor and antenna. Keep the ground wire as short as possible and make all ground connections to a single-point ground system to ensure no ground loop...

  • Page 16

    Models description list price bwc-4mnfn15 lmr400 n-type male to n-type female, 15 m $156 bwc-4mnfn30 lmr400 n-type male to n-type female, 30 m $296 model description connection list price bwc-lmrsfrpb surge suppressor, bulkhead, rp-sma type rp-sma to rp-sma $111 bwc-lfnbmn-dc surge suppressor, bulkh...

  • Page 17: 3 Maintenance

    3 maintenance follow these instructions to perform basic maintenance tasks. 3.1 replacing the main body gasket check the main body gasket every time a surecross device is opened. Replace the gasket when it is damaged, discolored, or showing signs of wear. The gasket must be: • fully seated within it...

  • Page 18

    4 troubleshooting problems on your dx70 network no leds. Recheck the power connections and power requirements. Dx70 devices require 10 to 30v dc. Signal led is solid red or flashing red for more than 30 seconds. If the devices are less than two meters apart, they may not communicate properly (radios...

  • Page 19

    4.2.1 setting the network id on the dx70s the network id is a unique identifier assigned to each wireless network that minimizes the chances of two collocated networks interfering with each other. Assigning different nids to different networks improves collocation performance in dense installations....

  • Page 20: Information

    5 advanced setup instructions and additional information refer to the following sections for advanced setup instructions or additional information on banner's surecross wireless technology and its uses. 5.1 binding the dx70 gateway and node dx70 gateway and node kits ship from the factory bound to e...

  • Page 21

    5.2 specifications radio range4 900 mhz, 150 mw: up to 4.8 km (3 miles) 2.4 ghz, 65 mw: up to 3.2 km (2 miles) radio transmit power 900 mhz, 150 mw: 21 dbm (150 mw) conducted 2.4 ghz, 65 mw: 18 dbm (65 mw) conducted, less than or equal to 20 dbm (100 mw) eirp 900 mhz compliance fcc id tgudx80 - this...

  • Page 22

    5.2.1 dx70 dimensions 65.0 [2.56”] 65.0 [2.56”] 80.3 [3.16”] 80.8 [3.18”] 60 [2.36”] 7.9 [0.31”] 7.65 [0.30”] 14.67 [0.578”] 106 [4.17”] 1/2” npt figure 3. Dx70 gateway and node dimensions 5.3 accessories the accessories list includes fcc approved antennas, antenna cabling, surge suppressors, power ...

  • Page 23

    Omni-directional antennas part no. Model no. Frequency description connection 1 76908 bwa-9o2-c 900 mhz 2 dbi, rubber swivel (ships with 900 mhz radios) rp-rma male 17721 bwa-9o5-c 5 dbi, rubber swivel 2 77816 bwa-2o2-c 2.4 ghz 2 dbi, rubber swivel, 3 1/4 inches (ships with 2.4 ghz radios) 77817 bwa...

  • Page 24

    5.3.2 dc power supplies models description list price ps24w dc power supply, 500 ma, 24 v dc, demo kit power supply $49 psdinm-24-04 dc power supply, 0.4 amps, 24 v dc, with din rail mount $35 psdinm-24-10 dc power supply, 1.0 amps, 24 v dc, with din rail mount $40 psdinm-24-17 dc power supply, 1.7 ...

  • Page 25

    Use these lmr100 cables to connect a radio to an n-type antenna, n-type antenna extension cable, or n-type surge suppressor. These cables may be used inside or outside the enclosure or without an enclosure. Part no. Model no. Description 77486 bwc-1mrsmn05 lmr100 rp-sma to n-type male, 0.5m 77820 bw...

  • Page 26

    Models description mqdmc-401 300 mm (12 in) cordset with a 4-pin m12/euro-style straight male quick disconnect (qd), single ended, longer for dx80…c models 5.3.6 other cables models description list price bwa-ribbon-001 ribbon cable, 20-pin dbl socket $9 bwa-hw-010 cable, flexpower current monitorin...

  • Page 27

    Swing panel kits models description list price bwa-ah1816spk swing panel kit, 18 × 16, includes mounts, screws, and panel $80 back panel kits models description list price bwa-bp66a back panel, aluminum, 6 × 6 $16 bwa-bp86a back panel, aluminum, 8 × 6 $17 bwa-bp108a back panel, aluminum, 10 × 8 $21 ...

  • Page 28

    Accessories models description list price bwa-ahak accessory kit, includes all screws, inserts, and mounting feet, replacement only $15 5.3.7 fiberglass enclosures models description list price bwa-ef14128 enclosure fiberglass hinged 14" × 12" × 8" $135 bwa-ef1086 enclosure fiberglass hinged 10" × 8...

  • Page 29: 6 Radio Certifications

    6 radio certifications banner's surecross product line is certified by the fcc, european union, and many other countries for operation within specific radio frequencies. 6.1 fcc certification, 900mhz the dx80 module complies with part 15 of the fcc rules and regulations. Fcc id: tgudx80 this device ...

  • Page 30

    6.2 fcc certification, 2.4ghz the dx80 module complies with part 15 of the fcc rules and regulations. Fcc id: ue300dx80-2400 this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this devi...

  • Page 31

    Radio modules country 900 mhz (150 mw) 900 mhz (1 watt) 2.4 ghz (65 mw) australia x austria x bahamas, the x x bahrain, kingdom of x belgium x brazil x bulgaria x canada x x x chile x china, people's republic of x colombia x x cyprus x czech republic x denmark x ecuador x el salvador x estonia x egy...

  • Page 32

    Radio modules country 900 mhz (150 mw) 900 mhz (1 watt) 2.4 ghz (65 mw) saudi arabia, kingdom of x singapore x slovakia x slovenia x south africa x spain x sweden x switzerland x taiwan (republic of china) x ** thailand x turkey x united arab emirates x united kingdom x united states of america x x ...

  • Page 33: 7 Warnings

    7 warnings 7.1 installing remote antennas install and properly ground a qualified surge suppressor when installing a remote antenna system. Remote antenna configurations installed without surge suppressors invalidate the manufacturer's warranty. Keep the ground wire as short as possible and make all...

  • Page 34

    India address: banner engineering india pune head quarters office no. 1001, 10th floor sai capital, opp. Icc senapati bapat road pune 411016, india phone: +91 (0) 206 640 5624 website: www.Bannerengineering.Co.In email: salesindia@bannerengineering.Com mexico address: banner engineering de mexico mo...

  • Page 35: Index

    Index a antenna remote installation 15 antenna installation remote 12–15 c certification fcc 29, 30 chemical exposure 10 collocation 11, 18 communication verify 8, 9 d determinism 18 dip switch access 5 e enclosure 9, 10 g gasket main body 17 ground 10 ground wire 12–15 i i/o isolation 12–15 i/o map...