Bantam HANDY-1 User Manual - page 2
Current Setting
Manual Voltage Setting
Voltage Auto Detection
Battery Type (Li-poy / Ni-Cd/MH)
3. Error (all of five LEDs will blink continously)
4. Charging Li-Polymer battery
5. Charging Ni-Cd/Ni-MH
6. Safety functions
7. Specfications
INPUT
Charging Rate : 0.1A~2.5A (50W)
Ni-Cd/MH : 1~12Cells
Micro Process Controlled
Li-Poly : 3.7V~18.5V (1~5Series)
Auto / Manual Voltage Selection
MULTI CHARGER
Li-POLY
Select
FULL
CHARGE
CURRENT
SELECT
C.C / C.V
Batt.Type
Caution
VOLTAGE
SELECT
Ni-Cd/MH
Auto
4) When the battery is fully charged 'FULL' LED(Green) will be on.
5) This charger can charge 1 to 12 cells of Ni-Cd or Ni-MH batteries. And it has the delta-peak
voltage detection for the completion of charging.
1) When the input power is lower than DC 11.0V of higher then DC 15.0V.
2) Bad connection of charging lead and battery.
3) If any of bad connection occurs on C.V Mode 'FULL' LED will be on.
4) When the charger detects the upper limit of voltage especially for the battery has large internal
resistance.
1) Set 'Battery Type Switch' for Li-Poly Mode.
2) Set voltage manually.
3) Or select 'Auto Detection'.
4) Select the 'Current Select' for the maximum of 1 C of the capacity of battery to be charged.
5) Connect the battery to a charging lead.
* In Manual mode, the unit will check the voltage of battery and the voltage you select for the first one
minute. If they are different from your setting the error will be shown.
* In Auto Detection mode, it checks the voltage of battery with the 1/10 of current you select for about
two minutes and then starts to charge.
* If the battery was discharged below 3.0V per cell the error may occur. In this case try charging 2~3
times repeatedly.
1) Set 'Battery Type Switch' for Ni-Cd/MH Mode.
2) Set 'Current Select'.
3) Connect the battery to a charging lead and it will start to charge.
1) Reverse polarity protection both input and output.
2) Safety check input voltage.
3) Self-protection for the short circuit during charging.
4) Built-in safety timer for the max. 12 hrs of charging. If over, it will be off automatically.
Input Voltage: DC11.0V~15.0V
Charging output: 50W
Li-Polymer: 3.70V~18.50V (1~5 series)
Ni-Cd/MH: 1~12 cells
Charge current: 0.1A~2.5A
Dimensions: W106 x H41 x D12 mm
Distributor
HEAD OFFICE
3rd 187-7 Gayang-Dong, Kangseo-Gu, Seoul Korea 157-200
PHONE (02) 3663-6433 FAX(02) 3663-6435
E-Mail : bantamtek@bantamtek.com
Web Site http://bantamtek.com