Summary of BT49QT-9
Page 1
Bt49qt-9 – user manual, service schedule & history.
Page 2: Introduction
Introduction welcome to your new baotian bt49qt-9, which has been developed by baotian motorcycle industrial co. Ltd. We hope you enjoy your new baotian bt49qt-9. This owner’s handbook contains information necessary: • to enable you to get to know your baotian bt49qt-9, to use it to the best advanta...
Page 3: Contents
Contents guidance............................................................................................................................................................1 names of parts..................................................................................................................
Page 4: Guidance
1 1. Pre-riding inspection please read the details in the relevant chapter for your safety. 2. Helmet do wear a helmet at all times while riding the motorcycle. 3. Being familiar with motorcycle operation it is of great importance to ensure your safety at all times, especially whilst becoming famili...
Page 5
5. Positions of the numbers when your motorcycle needs to be inspected, repaired or undertake any service, these numbers will assist your baotian dealer when servicing your motorcycle. Please note down your numbers here: the frame number:................................................ The engine nu...
Page 6
3 (1) front signal light (7) seat lock (13 rear signal light) (2) left front turning light (8) left rear turning light (14) stand (3) head light (9) starting pedal (15) helmet hook (4) rear brake lever (10) silencer (16) throttle control (5) rear-view mirrors (11) right rear turning light (17) instr...
Page 7
1. Rear brake lever hold it tight and the rear brake functions 2. Switches on the left handle a. Horn button b. Turning signal switch left turning light right turning light c. Switch for high/low beam lights 3 instruments and indicating lights a. Fuel gauge. B. Speedometer indicates the speed in km/...
Page 8
4. Front brake lever press it tightly and the front brake functions. 5. Switches on the right handle a. Head light switch b. Ignition button when the ignition switch is at on position, hold the brake and push the button ,and then the engine starts. 6. Ignition switch off the whole circuit is cut. En...
Page 9: Warning:
Starting lever starting lever is for kick starting the engine. Fuel tank usage of the cap: 1. Insert the key. 2. Turn it clockwise and take off the cap. 3. Fix the notch and then press the cap on. 6 ① warning: ◆ turn off the engine when refilling the tank. ◆ turn off the cap slowly. ◆ align the mark...
Page 10: Pre-Riding Inspection
Pre-riding inspection please check the following parts before you drive. 7 no. Items inspection content 1 handle bar 1.Easy movement. 2. No loose appearance 2 brake system 1.Check for fraying of cables. 2. Easy function 3 tyres 1. Correct pressure. 2. No splits in rubber 4 fuel sufficient fuel 5 eng...
Page 11: Engine Starting
Engine starting 1. Please check the volume of engine oil and fuel before starting. The main stand should be stood up while starting the engine. 2. Turn the ignition switch to the “on” position. 3. Engine starting push the starter button and then the engine starts. 8 press the rear brake lever “on” p...
Page 12
4. Kick starting grip the brake lever, kick the kick start pedal downwards 2 or 3 times in rapid succession. 9 warning: ◆ after the engine has started, the kick start pedal should be taken back to its original position. Otherwise, it will affect the driver’s safety. ◆ don’t start the engine in enclo...
Page 13
1. Battery • 12v/4ah battery • when the voltage is less than 11.5v, please use kicking start in stead of electric starting. • place the ignition switch to off position before battery replacement. • electrode identification: “+”-red line, “-“-black line. • replace the battery every 4 years. 2. Carbur...
Page 14
4. Spark plug • clean the carbon deposit on the spark plug with a piece of hard wire or steel needle. • adjust the gap to 0.6-0.7mm with a feeler gauge. • use (ngk) c7hsa when replacement is needed. 5. Fuel always refill with unleaded petrol. Try to refill before the needle reaches the red zone of t...
Page 15: 7. Brake System
7. Brake system normal free travel of the brake lever is about 10-20mm. 1. The front brake (disk brake) 2. The rear brake (drum brake) turn the adjusting nut to get a proper travel. _ 12 warning: important please make sure that an initial inspection is conducted after the first 300 km and thereafter...
Page 16
Brake fluid level • it has been filled with the special brake fluid before the motorcycle leaves the factory. Fluid should only ever be replace or filled with dot4 brake fluid. Never replace or mix other fluids, otherwise it will damage the brake system. • if the brake fluid level is insufficient, i...
Page 17
9. Starter motor check the fastening bolts and the contact brushes, and replace them if necessary. 10. Fuse an inline fuse is located in the live wire from the battery. When a light or circuit fails suddenly, please check the fuse first. 11. Gear oil • please use the recommended gear oil: sae 5w/90 ...
Page 18: Technical Parameters
Technical parameters 15 size length 1660mm width 680mm height 1070mm wheel base 1195mm min. Distance above ground 80mm weight unloaded weight 85kg loaded weight 75km / 150kg (1 seat / 2 seats) mass weight 165kg / 235kg (1 seat / 2 seats) capacity max. Speed 45km/h (e-mark) or 60 km/h min speed ≤1.8k...
Page 19: Regular Maintenance
Volume of the fuel tank 6.5l volume of the engine oil tank 1l engine model bt139qmb type 4 stroke cylinder 1 bore and stroke 39 x 41.5mm cylinder volume 49.5ml compression ratio 10.5:1 max. Power 2.2 kw / 7500 (r/min) max. Torque 2.9 nm / 7000 (r/min) carburetor pz18j air cleaner polyurethane plasti...
Page 20
17 br y l/w g y/r b g/y lg lb g br g l lb o r/w y/w b g l g w o g br w l l/w o gr lb lg b b g/y w l/w l lb gr o lg b l/w g o w g l br g b y/w r/w o lb l g br g lb g br y y/r g/y g/y b b r b g g g r/w y/w r g y w g y g/y y/r r r r g g g/y g/y g g g g lb o lb g/y g o g g b/y b/y l/y g g b/r g gr b y g...
Page 21
Baotian warranty in the event of a sudden mechanical or electrical failure please contact your supplying dealer. Your 24-month warranty covers your scooter/motorcycle in the event of mechanical breakdown or component failure. The first 12 months of cover extends to the entire scooter with the except...
Page 22
19 initial inspection mileage: date: dealer stamp: service 2 mileage: date: dealer stamp: service 1 mileage: date: dealer stamp: service 3 mileage: date: dealer stamp:.
Page 23
20 service 4 mileage: date: dealer stamp: service 6 mileage: date: dealer stamp: service 5 mileage: date: dealer stamp: service 7 mileage: date: dealer stamp:.
Page 24
21 service 8 mileage: date: dealer stamp: service 10 mileage: date: dealer stamp: service 9 mileage: date: dealer stamp: service 11 mileage: date: dealer stamp:.
Page 25
22 service 12 mileage: date: dealer stamp: service 14 mileage: date: dealer stamp: service 13 mileage: date: dealer stamp: service 15 mileage: date: dealer stamp:.
Page 26
23 maintenance schedule pdi 300 km 1,000 km 3,000 km 6,000 km 9,000 km 12,000 km every 2 years engine oil replace replace replace replace replace replace gear oil replace replace replace oil strainer clean clean clean replace clean replace air filter clean clean replace clean replace battery charge ...