1. DL manuals
  2. BAR-BE-QUICK
  3. Grill
  4. Grill & Bake
  5. Assembly Instructions Manual

BAR-BE-QUICK Grill & Bake Assembly Instructions Manual

Summary of Grill & Bake

  • Page 1

    Bq2121-1a trolley grill & bake barbecue before you start assembling your barbecue here are some important safety warnings do not use indoors. Always site your barbecue outdoors and on level ground away from trees and wooden fencing. Caution! Do not use spirit or petrol for lighting or re-lighting. U...

  • Page 2

    A b c d e f g h j k l m n o p q r s t u v w x top cover handle top cover right hand wind shield rear wind shield warming basket lid stays right top shelf oven short legs long shelf supports axle top cover handle brackets temperature gauge left hand wind shield cooking grill grill handles left top sh...

  • Page 3: Components

    Door stay linkage x 1 top cover handle stud x 1 m6 x 14mm screws x 16 m6 washer-nuts x 39 m6 x 16mm screws x 2 m6 fibre washers x 8 m6 x 10mm screws x 21 m6 washer x 2 m5 washer-nuts x 6 axle spacers x 2 m5 x 10 screws x 6 m8 nyloc nuts x 2 m6 domed nuts x 2 m8 washers x 2 m6 spanner x 1 m5 spanner ...

  • Page 4: Assembly Instructions

    Important please read the following instructions carfully and completely before attempting to assemble the barbecue. Keep all polythene wrappers away from children and dispose of all wrapping cartons thoughtfully. Great care is taken during the manufacture of your barbecue to eliminate sharp edges. ...

  • Page 5

    Stage two - assemble the top shelf and legs place the oven upside down on a clean, non abrasive surface with the oven door facing you. Take the two long legs and the top shelf (with handle on it) . Attach them to the right of the oven using four m6 x 14mm screws, washer-nuts per leg . Use the spanne...

  • Page 6

    Place the rear wind shield against the back of the fire tray facing inwards and locate loosely in posi- tion via an m6 x 10mm screw , washer-nut in the lower central fixing hole. See drawing 10 stage three - assemble the lid stage four - assemble the wind shield attach the top cover to the oven with...

  • Page 7

    Loosely fit the right and left hand wind shield via the lower fixing holes using 2 off m6 x 10mm screws , washer-nuts for the rear holes, 2 off m6 x 16mm screws, washer-nuts for the side locat- ing holes. See drawing 11. Push the right and left windshields inward to locate at the right positions and...

  • Page 8

    8 make sure the assembly instructions have been followed correctly. How to light we recommend you light your lumpwood / briquettes with bar-be-quick lighting fluid, gel or cubes. Using cubes (if using traditional lumpwood or briquettes) place two or three cubes in the firetray. Pile the lumpwood / b...