Rs232 dongle plug & scan communication protocol ©baracoda rs232 dongle plug & scan communication protocol baracoda tm – august 2008 data capture for workforce in motion rs232 dongle plug & scan.
Rs232 dongle plug & scan – communication protocol v3.27.1 - 2 - data capture for workforce in motion summary summary summary summary summary ................................................................... 2 revision history .......................................................... 3 1. Introduc...
Rs232 dongle plug & scan – communication protocol v3.27.1 - 3 - data capture for workforce in motion revision history revision history revision history revision history changes to the original manual are listed below. Document date description 3.27 06 aug 08 initial release 3.27.1 20 aug 08 updated ...
Rs232 dongle plug & scan – communication protocol v3.27.1 - 4 - data capture for workforce in motion 1. 1. 1. 1. Introduction 1.1. 1.1. 1.1. 1.1. Generalities the plug&scan solution enables a simple, reliable and efficient use of its compatible barcode readers (the whole baracoda product range) than...
Rs232 dongle plug & scan – communication protocol v3.27.1 - 5 - data capture for workforce in motion 1.2. 1.2. 1.2. 1.2. Generic packet the dongle will parse data respecting a specific format. 1.2.1. 1.2.1. 1.2.1. 1.2.1. Rs232 rs232 rs232 rs232 all the frames incoming to the rs232 dongle are formatt...
Rs232 dongle plug & scan – communication protocol v3.27.1 - 6 - data capture for workforce in motion 2.1.1. 2.1.1. 2.1.1. 2.1.1. Get version get version get version get version the response to a “get version” command (codeid 0x76) is sent raw via rs232. 2.1.2. 2.1.2. 2.1.2. 2.1.2. Command responses ...
Rs232 dongle plug & scan – communication protocol v3.27.1 - 7 - data capture for workforce in motion 2.2. 2.2. 2.2. 2.2. Host to dongle messages 2.2.1. 2.2.1. 2.2.1. 2.2.1. Communication messages communication messages communication messages communication messages code id 0x02 command disconnect des...
Rs232 dongle plug & scan – communication protocol v3.27.1 - 9 - data capture for workforce in motion code id 0x31 command set upload messages use description enable/disable use of upload messages payload 1 byte: { 1 : enable 0 : disable (default)} response none code id 0x4b command set ack mode desc...
Rs232 dongle plug & scan – communication protocol v3.27.1 - 10 - data capture for workforce in motion code id 0xfe command event messages description these are dongle to host messages. These inform the host about some events concerning the dongle’s operation. Payload 1 to n bytes : {event id} {n-1 b...
