Baracoda BL 1000 User Manual - page 6
BL 1000 user guide
Clear Bar codes
Return to factory default
8Safety/Regulatory
FCC Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference (2) this device must accept any interference received including interference that may cause undesired operations. This applies to all
product options. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment. (in accordance with FCC Part 15.21)
FCC Radio Frequency Interference Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
» Reorient or relocate the receiving antenna.
» Increase the separation between the equipment and receiver
» Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
» Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this
device and all persons. This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter. CAUTION: Changes
or modifications to this equipment not expressly approved by Baracoda could void the user's authority to operate this equipment.
Notice for Canada
Radio interference notice for Canada. This class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de Classe B est conforme à la norme NMB-003 du Canada.
Compliance Information
Product Name: Flic Cordless Laser Bar Code Scanner
Product Number: HS2141
Product Options: All
The product herewith complies with the requirements of Low Voltage Directive 73/23/EEC, EMC Directive 89/336/EEC, R&TTE Directive 99/5/EC, and
carries the "CE" mark accordingly. The equipment also carries the Class 2 equipment identifier: Complies with 21 CFR 1040.10 and 1040.11 except for
deviations pursuant to Laser Notice No. 50, dated July 26, 2001.
Laser
Type: Semiconductor laser aAlGaInP
Maximum output power: 5mW
Divergence: X axis: 6-15 degrees
Wavelength: 650-660nm
Y axis: 22-38 degrees
Laser Safety
This device employs a laser. Do not remove the cover or
attempt to service this device due to the possibility of eye
damage.
Caution
Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous laser
radiation exposure.
© Baracoda 2003
Page 5/6