Baracuda alpha 3 Owner's Manual And Quick Installation Instructions - page 15
ADJUSTMENTS
BALANCE
Even with the proper flow, a hose weight (part number 43260) may be necessary to
balance the Alpha 3 cleaner head. If the Alpha 3 will not balance correctly in the deep
end of the pool, (as shown below), turn off the pump and add the hose weight
approximately 4 to 7 feet, or 1
1
/
2
to 2 hose sections away from the cleaner head.
If your pool is 8 feet deep or greater, you may need to purchase a heavier hose weight
(part number 43317) from your Baracuda dealer. Position this weight 9 feet or 2
1
/
2
hose sections away from the cleaner head. In unusual situations both weights may be
required, with the heavier hose weight (43317) at 9 feet away from the cleaner head
and the lighter weight (43260), 12 feet away from the cleaner head. The primary
reason for the hose weight is to maintain the hose at a 45˚ angle to the pool
cleaner.
Correct
Incorrect
Incorrect
COVERAGE
Normally it is undesirable for the return line water flow to affect the natural
movement of the Alpha 3 hose. However, the following illustration shows how return
line pressure can be used to balance cleaning coverage or to guide the cleaner away
from step areas with “V” shaped corners.
A return line located anywhere along the shaded area can be utilized to gently push
the hose allowing the Alpha 3 to free itself from in-pool obstacles.
TECHNIQUE
Position the return line directional so that you can only detect water movement on the
surface 8 feet out from the wall, and aim it at the center of the opposite wall.
15