Page 1 welcome to the world of barbeques galore outdoor cooking instructions for assembly and use of cordon bleu l2-series barbeque carts for the safe use and enjoyment of your new barbeque. For models: mc2cbl, mc4cbl.
Page 2 contents list 1 x left side panel (cp9095528+cp9095530) 1 x right side panel (cp909905528+cp9095530) 1 x base shelf 2b(cp9095531+cp9095532) 4b(cp9095581+cp9095582) 1 x rear panel 2b (cp9095529) 4b (cp9095579) 2 x castors with lock (each with 1 x m10 nut) (cp9095267) 2 x castors without lock (...
Page 3 assembly instructions step 1: attach the castors what you need 2 x castors with lock (each with m10 nut) 2 x castors without lock (each with m10 nut) 4 x m10 flat washers 4 x m10 spring washers (a) remove the m10 nuts, then screw the 4 castors onto the underside of the base shelf (2 castors w...
Page 4 assembly instructions (continued) step 2: fit the anti-tilt feet (for the 2b stand alone only – ignore for 6b or for 4b stand alone) what you need 4 x springs 4 x support plate 4 x m6 nuts for the 2b barbeque on cart as a stand-alone unit, the anti-tilt feet need to be extended as in above im...
Page 5 assembly instructions (continued) step 3: attach the side panels what you need 6 x m6*15mm round head screws (4b) 6 x m6*15mm round head screws (2b) a) position 2 side panels onto the base shelf, and fix in place with m6x15mm screws. B) lock the two "l" brackets in place with 2 x m6*15mm scre...
Page 6 assembly instructions (continued) step 4: attach the rear panel what you need 6 x m6*15mm screws using a m6 screw, secure the rear panel. You do not need any nuts – the screws go into the the threaded holes in the base shelf or the side panel. Step 5: attach the upper door brackets what you n...
Page 7 assembly instructions (continued) step 6: attach the doors start by locating the door lower pin into the hole in the base panel. Swing the top of the door into position near the upper door bracket. Push the hinge pin down and allow it to the spring back into the hole in the upper bracket the ...
Page 8 assembly instructions (continued) step 7: if purchased, fit the optional slide out drawer what you need 8 x m6*15mm screws 8 x m6 flange nuts 1 x slide out drawer follow the instructions with the bbq to connect and fit a gas cylinder where required..
Page 9 assembly instructions (continued) step 8: if purchased, fit the optional storage rack. For units that do not require gas cylinders, the racks can fit in place of the optional slide out drawer. The racks can also fit onto the optional slide out drawer to create a slide out storage rack system....
Page 10 assembly instructions (continued) step 9: if required, level the cart by adjusting the castor height. This is more often necessary when multiple carts are joined together. If the cart doors are not aligned, usually it is because the assembly is not properly level or the screws not properly t...
