2002 invensys. All rights reserved technical manual models dynz-60010- 8 to 40 vdc dynz-60012- 59 to 88 vdc dynz-60013- 8 to 40 vdc electronic speed switch f-23371 barber-colman dyna products p.O. Box 2940 1354 clifford avenue loves park, il 61132-2940 usa tel: + 1 815 637 3000 fax: + 1 815 877 0150...
2002 invensys. All rights reserved table of contents 1.0 introduction 1 2.0 specifications 1 3.0 additional features 2 4.0 wiring instructions 3 5.0 operation and calibration of dynz-60010 3 6.0 operation and calibration of dynz-60012 and dynz-60013 4 7.0 troubleshooting 5 uncontrolled document for ...
F-23371 electronic speed switch technical manual page 1 2002 invensys. All rights reserved 1.0 introduction the barber-colman two setpoint speed switch normally obtains its input signal from a magnetic pickup which is positioned in proximity to the teeth of a gear on a rotating shaft. The pickup gen...
F-23371 electronic speed switch technical manual page 2 2002 invensys. All rights reserved relay contact rating: 10.0 amperes at 30 vdc resistive. Overspeed response time: with the overspeed set at 4140 hz and a steady input frequency of 3600 hz, then switching the input frequency to 5000 hz must re...
F-23371 electronic speed switch technical manual page 3 2002 invensys. All rights reserved l barber-colman sets the units to operate over the adjustment range of 325 to 10,000 hz by cutting jumper j2 only. The sensitivity of the adjustment potentiometer is approximately 480 hz per turn. N sw1 is fac...
F-23371 electronic speed switch technical manual page 4 2002 invensys. All rights reserved requirements. If set/trip point of sw1 is correct it is properly calibrated. If set/trip point is incorrect, go to step 5.3.2, 5.3.3 and 5.3.4 and calibrate unit. 5.4 calibration or checking procedure for os-s...
F-23371 electronic speed switch technical manual page 5 2002 invensys. All rights reserved 6.3.3 adjust the signal generator frequency to the desired sw1 set/trip point as specified or calculated in step 6.2.1. 6.3.4 slowly turn the sw1 setpoint potentiometer adjustment counterclockwise until the oh...
