Barber-Colman MACO 4000 Series Instruction Manual
1640-IN-026-A-00
Page 1 of 10
Copyright © 1995 Barber-Colman Company
1640-IN-026-A-00
July 1995
MACO
®
4000, 5000 & 6000 Series
SPI Auxiliary Equipment Interface
Protocol
Instruction Manual
Table of Contents
1.0
Introduction ....................................................... 2
2.0
Setup Instructions ............................................ 2
2.1
Board Location ......................................... 2
2.2
Jumpers and Switches ............................. 2
2.3
Node Address .......................................... 2
2.4
MACO Serial Communication Setup ........ 2
2.4.1 Modfiles and Sample Screens ................. 2
2.4.2 COMM Setpoints ...................................... 2
2.5
Wiring ....................................................... 3
2.6
Error Codes Screen ................................. 4
2.6.1 Baud Rate Setpoints ................................ 4
2.6.2 SPI Status Relays .................................... 4
3.0
SPI Screens and RLD Programming ............... 5
3.1.0 List of SPI Devices Supported ................. 5
3.1.1 Mold Temp Controller Commands ........... 5
3.1.2 Chiller Commands ................................... 5
3.1.3 Dryer Commands ..................................... 5
3.1.4 Loader Commands .................................. 6
3.1.5 Melt Pump Commands ............................ 6
3.1.6 Additive Feeder Commands .................... 6
3.1.7 Self-tune Temp Controller Commands .... 6
3.1.8 General Purpose Temp Controller
Commands ............................................... 6
3.1.9 Robot Commands .................................... 6
3.2
Setup Screen ........................................... 7
4.0
Status and STM/MTS Control Relays .............. 8
4.1
Status control relays ................................ 8
4.2
STM/MTS control relays .......................... 9
4.2.1 Building the STM/MTS Table ..................... 9
5.0
SPI Status Monitor / setup screens ............... 10