Barco DP2K-S Series Quick Start Manual - page 3
Trained projectionist
Power up
Power up
Play a movie controlled by the server
Play a movie controlled by the server
Play a movie manually
Play a movie manually
Power down
Power down
DP2K S-series
Quick Start Guide
1
1
1
2
3
4
5
6
2
3
4
5
1
2
3
2
3
4
5
Press Standby button or switch off lamp with Communicator.
Lamp is switched off and cool down starts.
Allow the projector to cool down for at least 5 minutes until
the speed of the fans decreases.
Switch off the projector.
Important!
Damage will result if you do not allow the lamp to
cool down.
1
2
Press Standby button or switch off lamp with Communicator.
Lamp is switched off and cool down starts.
Press Sleep button for 3 seconds. When the lamp is still too
hot, the projector will finish first the cool down process. Then
it goes into sleep mode. Power consuption is less than 15W.
No fans are turning and lamp power supply is switched off
completely.
During normal operations, the server should start the
projector automatically. If it does not start automatically, use
the following steps.
Press Standby button. Check if button turns green.
Select the appropriate macro for the next show. Allow a
moment for the lens to move into position
Press Dowser button if required.
Play the movie from the server.
Check the image on screen for proper alignment and color.
Optional: if the image is not aligned with the screen masking,
use the Lens adjustment buttons to correct the image on
screen. Be sure to notify the theatre technician.
General
Ensure that the exhaust system is properly installed.
Press the Power Switch to switch the projector ON. Allow up
to one minute for the projector to finish the boot-up sequence.
Note: projector starts up in the same state as it was switched
off. When switched off in sleep mode, it starts up in sleep
mode, when switched off in standby, it starts up in standby.
Projector status light turns green or flash green. If the status
ligth turns or flashes red, yellow or blue, refer to the trouble-
shooting section.
When it starts up in sleep mode, press Sleep button for 3
seconds or wake up projector via Communicator. Projector
goes in standby. Press Standby button or activate lamp via
Communicator.
When it starts up in standby mode, press Standby button or
activate lamp via Communicator.
Press Dowser button or open dowser via Communicator.
DOWSER
DOWSER
Play the movie from the server.
Check if the Standby button turns green.
Check if the Dowser button turns green.
Check that the appropriate macro is selected.
Check the image on screen for proper alignment and color.
Optional: if the image is not aligned with the screen
masking, use the Lens adjustment buttons to correct the
image on screen. Be sure to notify the theatre technician.
5min
Put in Sleep mode
Put in Sleep mode
3
C
M
Y
CM
MY
CY
CMY
K
r5905465_00_userguide.pdf 3 17-12-2012 9:20:11